819077
37
Zoom out
Zoom in
Previous page
1/52
Next page
Message Cause Action
Temperature restric-
tion
The product does not operate if the battery
temperature is too high or too low.
The product starts to operate again when the
temperature is between the set limits and the
schedule settings let the product to operate.
Make sure that the charging station is put in
an area with protection from the sun.
Charging current too
high
The battery charges with a too high current.
The power supply unit is incorrect or dam-
aged.
Make sure that the power supply unit and
charging station are not damaged. Make
sure the that you use the correct power sup-
ply unit and charging station. Restart the
product. If the problem stays, speak to your
authorized service center.
Charging system
problem
There is corrosion or dirt on the charging
plates and contact plates.
Restart the product. Clean the charging
plates on the product and the contact plates
on the charging station.
Temporary electronic or firmware problem in
the product.
Restart the product. If the problem stays,
speak to your approved servicing dealer.
No power in charging
station
The power supply unit is incorrect or dam-
aged.
Examine the power supply unit. Replace if
necessary.
Power failure. Find and correct the cause of the power fail-
ure.
The product cannot charge because there is
no contact between the contact plates and
the charging plates.
Make sure that the charging plates and the
contact plates are in contact. Clean the con-
tact plates and charging plates.
Charging station
blocked
The product cannot go into the charging sta-
tion because it is blocked or the baseplate of
the charging station is tilted or bent.
Examine why the product cannot go into the
charging station. Remove any objects and
make sure that the baseplate of the charging
station is level.
The product cannot go into the charging sta-
tion because it is blocked or the baseplate of
the charging station is tilted or bent.
Examine why the product cannot go into the
charging station. Remove any objects and
make sure that the baseplate of the charging
station is level.
Stuck in charging sta-
tion
The product cannot leave the charging sta-
tion because it is blocked or it slips on the
baseplate of the charging station.
Examine why the product cannot leave the
charging station. Remove any objects and
clean the baseplate of the charging station.
FlexiFence problem
The battery of the FlexiFence accessory is
low. The FlexiFence accessory does not op-
erate when the battery is empty. The product
can cut in the stay-out zone if you start the
product before you charge the FlexiFence
accessory.
Park the product and charge the FlexiFence
accessory before you start the product.
The temperature in the FlexiFence accessory
is a higher than the maximum limit and is set
to off.
Put the product in an area with protection
from the sun. Let the temperature of the
FlexiFence accessory decrease before you
start the product.
Boundary wire prob-
lem
The boundary wire for the
Support by wire
function is damaged or not installed correctly.
Examine that the boundary wire is connected
correctly to the charging station. Examine all
the splices on the boundary wire. Examine if
the boundary wire is damaged and repair it if
it is necessary.
2071 - 002 - 05.02.2024 Troubleshooting - 37
37


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Husqvarna Automower 430X NERA - 2024 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Husqvarna Automower 430X NERA - 2024 in the language / languages: English as an attachment in your email.

The manual is 4.37 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Husqvarna Automower 430X NERA - 2024

Husqvarna Automower 430X NERA - 2024 Quick start guide - English, German - 8 pages

Husqvarna Automower 430X NERA - 2024 User Manual - German - 52 pages

Husqvarna Automower 430X NERA - 2024 User Manual - Dutch - 52 pages

Husqvarna Automower 430X NERA - 2024 Quick start guide - French, Italian - 8 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info