819071
10
Zoom out
Zoom in
Previous page
1/48
Next page
EN, English
Operator's manual
HUSQVARNA AUTOMOWER®
310E NERA/410XE NERA
Read the operator's manual carefully and make sure that you
understand the instructions before you use the product.
The product must only be operated, maintained
and repaired by persons that are fully conversant
with its special characteristics and safety
regulations.
It is not permitted to change the initial design of the
product.
Obey national regulations about electrical safety.
Husqvarna does not guarantee full compatibility
between the product and other types of
wireless systems such as remote controls, radio
transmitters or equivalent.
The built-in alarm is very loud. Be careful,
especially if the product is handled indoors.
Operation and storage temperature range is 0-45
°C / 32-113 °F. Temperature range for charging is
5-45 °C / 41-113 °F. Too high temperatures can
cause damage to the product.
1.3 Safety instructions for installation
WARNING: Read the warning
instructions that follow before you use the
product.
Do not install the charging station, including any
accessory, at a location that is below, or within 60
cm / 24 in. from, any combustible material. In case
of malfunction, heating of the charging station and
the power supply may occur and create a potential
risk of fire.
Do not put the power supply at a height where
there is a risk it can be put in water. Do not put the
power supply on the ground.
Do not encapsulate the power supply. Condensed
water can harm the power supply and increase the
risk of electrical shock.
Do not install the charging station where there are
pests, for example ants.
Applicable to USA/Canada. If power supply is
installed outdoors: Risk of Electric Shock. Install
only to a covered Class A GFCI receptacle (RCD)
that has an enclosure that is weatherproof with the
attachment plug cap inserted or removed.
Do not install the charging station where there is a
risk of standing water.
1.4 Safety instructions for operation
WARNING: Read the warning
instructions that follow before you use the
product.
Keep your hands and feet away from the rotating
blades. Do not put your hands or feet near or
below the product when it is set to ON.
Use the park mode or set the product to OFF when
persons, especially children or animals are in the
work area. Refer to
To set the product to OFF
on page 25
. Husqvarna recommends to set the
product to operate when the work area has no
activity. The product can cause injury to animals at
night in work area, for example hedgehogs. Refer
to
Operating modes - Park on page 25
.
Make sure that there are no objects such as
stones, branches, tools or toys on the lawn. The
blades can be damaged if it hits an object.
Do not lift the product or move it when it is set to
ON.
Do not to let the product collide with persons or
animals. If a person or animal comes in the way of
the product, stop the product immediately. Refer to
To stop the product on page 25
.
Do not put objects on top of the product or its
charging station.
Do not use the product if the STOP button does
not work.
Always set the product to OFF when it is not in
operation. The product can only start when you
enter the correct PIN code.
Do not use the product at the same time as a
pop-up sprinkler. Use the
Schedule
function so the
product and pop-up sprinkler do not operate at the
same time. Refer to
Schedule on page 20
.
Do not let the product operate when there is
standing water in the work area. For example when
heavy rain forms pools of water.
1.5 Safety instructions for maintenance
WARNING: Read the warning
instructions that follow before you do
maintenance on the product.
Set the product to OFF when you do maintenance
on the product.
Do not use a high-pressure washer to clean the
product. Do not use solvents to clean the product.
Disconnect the plug to the charging station before
you clean or do maintenance of the charging
station.
1.6 Battery safety
WARNING: Read the warning
instructions that follow before you use the
product.
Lithium-ion batteries can explode or cause fire if
disassembled, short-circuited, exposed to water,
fire, or high temperatures. Handle carefully, do
not dismantle, open the battery or use any type
4 - Safety 2369 - 001 - 05.02.2024
of electrical/mechanical abuse. Avoid storage in
direct sunlight.
1.7 To lift and move the product
WARNING: The product must be set to
OFF before you lift the product. The product
is disabled when the indicator on the jog
wheel goes off.
CAUTION: Do not lift the product when
it is parked in the charging station. It can
cause damage to the charging station and/or
the product. Push the STOP button and
pull the product out of the charging station
before you lift it.
To safely move the product from or in the work area:
1. Push the STOP button to stop the product.
2. Set the product to OFF.
3. Lift the product by the handle with the blade disc
away from your body.
2369 - 001 - 05.02.2024 Safety - 5
2 Introduction
2.1 Introduction
Factory PIN code: 1234
Serial number:
Product number:
The serial number and the product number are on the product rating plate and on the product carton.
Register your product on www.husqvarna.com. Enter the serial number of the product, the product number and
the date of purchase to register your product.
2.2 Support
For support about the product, speak to your Husqvarna
servicing dealer.
2.3 Product description
Note: Husqvarna regularly updates the appearance
and function of the products. Refer to
Support on page
6
.
The product is a robotic lawn mower. The product has a
battery power source and operates automatically. When
the battery state of charge is low the product goes to the
charging station to charge. The product starts to operate
again when the battery is fully charged.
The movement pattern of the product is random, which
means that the lawn is cut equally and with less wear.
The product has EdgeCut which makes the product cut
the edges of your lawn. The frequent cutting technique
improves the grass quality and decreases the use of
fertilizers. Collection of grass is not necessary.
2.3.1 Installation method
You can install the product with a boundary wire or
without boundary wire with EPOS. A boundary wire is
not necessary if you install the product with EPOS.
For installation of the boundary wire, refer to
Installation
with wire on page 12
. For installation with EPOS,
read the operator’s manual that is included with the
reference station.
2.3.2 Automower® Connect
Automower® Connect is a mobile application that makes
it possible to select the operation settings remotely.
Automower® 310E NERA can connect to the app
with Bluetooth® and Wi-Fi. Automower® 410XE NERA
can connect to the app with Bluetooth®, Wi-Fi and
cellular connectivity. When you are near the product
you can connect your mobile device and the product
with Bluetooth®. It is necessary to be connected with
Bluetooth® to make some settings. When the product
is connected to your Wi-Fi network or to the cellular
network you can control the product from everywhere.
You can also make the settings of the product. Refer to
Installation with wire on page 12
.
2.3.3 Automower® Access
Automower® Access is the user interface of the product,
it includes the display, the jog wheel, the START
button and the STOP button. In Automower® Access
you can set the cutting height and start, stop and
park the product. Refer to
Menu structure overview in
Automower® Access on page 10
.
2.3.4 Automower® Intelligent Mapping
(AIM)
Automower® Intelligent Mapping (AIM) is available in the
Automower® Connect app. Use Automower® Intelligent
Mapping (AIM) to make a virtual map of your lawn
and installation. For Automower® 410XE NERA you can
make virtual work areas and stay-out zones in the map.
Refer to
Automower® Intelligent Mapping (AIM) on page
24
.
6 - Introduction 2369 - 001 - 05.02.2024
2.4 Product overview
Automower® 310E
NERA
Automower® 410XE
NERA
31
23
26 27 28 29 30
8
13
6
7
2
45
12
14 17
18
19
15
16
3
20
21
22
9
10
11
35
36
24
25
33
34
32
1
1. Rating plate1
2. Top cover
3. Front wheels
4. Product body
5. Accessory hub
6. Radar2
7. Headlights3
8. Display
9. START button
10. Jog wheel
11. STOP button
12. Blade disc guard
13. Rear wheels
14. Skid plate
1Found below the top cover.
2Only for Automower® 410XE NERA.
3Only for Automower® 410XE NERA.
2369 - 001 - 05.02.2024 Introduction - 7
15. Chassis with electronics, battery and motors
16. EdgeCut blade disc
17. Main blade disc
18. Handle
19. Contact plates
20. LED indicator of the charging station
21. Hatch
22. Charging station
23. Low-voltage cable
24. Power supply4
25. Extra blades
26. Screws to attach the charging station
27. Measurement gauge for installation of the
boundary wire (the measurement gauge is
removed from the carton of the product)
28. Operator’s manual and Quick guide
29. Cable markers
30. Alarm decal
31. Stakes5
32. Loop wire for boundary wire and guide wire 6
33. Connectors for the loop wire7
34. Couplers for the loop wire8
35. Reference station EPOS RS19
36. Automower® EPOS Plug-in10
2.5 Symbols on the product
These symbols can be found on the product. Make sure
that you understand them.
WARNING: Read the opera-
tor instructions before you op-
erate the product.
WARNING: Disable the prod-
uct before maintenance or
before you lift the product.
WARNING: Keep a safe dis-
tance from the product when
it is in operation. Keep your
hands and feet away from the
rotating blades of the product.
WARNING: Do not sit on
the product. Do not put your
hands or feet near or below
the product.
Use a detachable power sup-
ply as specified on the rating
plate adjacent to the symbol.
This product complies with the applicable
EU Directives.
This product complies with the applicable
UK Directives.
It is not permitted to dispose the product
as usual domestic waste. Obey national
regulations and use the local recycling
system.
The chassis contains components which
are sensitive to electrostatic discharge
(ESD). The chassis must only be opened
and sealed by an authorized service
technician. The warranty will not be
applicable if the seal is broken.
4The appearance can be different for different markets.
5Purchased separately.
6Purchased separately.
7Purchased separately.
8Purchased separately.
9Purchased separately.
10 Purchased separately.
8 - Introduction 2369 - 001 - 05.02.2024
Battery level.
2.8.2 Menu structure overview in Automower® Access
9
8
7
6
5
4
3
2
1
2.8.2.1 Symbols in the main menu for Automower®
Access
Cutting height
In the
Cutting height
menu you can adjust
the cutting height in 9 steps.
Park
In the
Park
menu you can set the product
to park until further notice or to the set
schedule.
Mow
In the
Mow
menu you can set the product
to cut to the set schedule or in secondary
area mode.
Connect
In the
Connect
menu you can enable
Bluetooth® and make a pairing operation
with your mobile device.
10 - Introduction 2369 - 001 - 05.02.2024
Language
In the
Language
menu you can select a
language in the display.
Power off
Power off
sets the product to OFF.
2.8.2.2 Symbols in the submenu for Automower®
Access
Cutting height
In the
Cutting height
submenu you can
select a cutting height for the product.
Back
If you select
Back
, you go back to the
main menu.
Schedule
In the
Schedule
submenu you can select
the
Schedule
settings. The
Schedule
settings are set in the Automower®
Connect app.
Selected operation mode
In this submenu you can select the
product to operate continuously in the
selected operation mode. The product
continues to operate in this mode until you
select a new operation mode.
Secondary area
In the
Secondary area
submenu you
can select the
Secondary area
operation
mode. Refer to
Secondary area on page
25
.
Connected
The product and mobile device are
connected with Bluetooth®.
Not Connected
The product and mobile device are not
connected with Bluetooth®.
2369 - 001 - 05.02.2024 Introduction - 11
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Husqvarna Automower 410XE NERA - 2024 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Husqvarna Automower 410XE NERA - 2024 in the language / languages: English as an attachment in your email.

The manual is 4.01 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Husqvarna Automower 410XE NERA - 2024

Husqvarna Automower 410XE NERA - 2024 User Manual - German - 48 pages

Husqvarna Automower 410XE NERA - 2024 User Manual - Dutch - 48 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info