733974
22
Zoom out
Zoom in
Previous page
1/36
Next page
2. Connect the product to the harness.
3. Adjust the harness for the best work position.
4. Adjust the side straps to make the product weigh
equally on your shoulders.
5. Adjust the harness until the cutting attachment is
parallel to the ground.
6. Let the cutting attachment lightly touch the ground.
Adjust the harness clamp to balance the product
correctly.
Note: If you use a grass blade, it must balance
approximately 10 cm /4 in above the ground.
Operation
Introduction
WARNING: Read and understand the safety
chapter before you use the product.
To examine the product before
operation
Examine the motor for dirt and cracks. Use a brush
to remove grass and leaves from the engine. Wear
protective gloves when necessary.
Make sure that the trimmer head is fully attached to
the product.
Do the safety inspections, maintenance and
servicing that are given in this manual.
Make sure that the product is not damaged. Examine
that all nuts and screws are tight.
Make sure that there are no cracks on the blade.
Cracks usually occur when you make too sharp
corners at the bottom of the teeth while you sharpen
the blade. Cracks can also occur if you use the blade
with blunt teeth. Replace the blade if it is damaged.
Examine the support flange for cracks. Replace the
support flange if it is damaged.
Make sure that the locking force on the locknut is not
decreased. The locknut must have a locking force at
a minimum of 1.5 Nm. The tightening torque of the
locknut must be between 35-50 Nm.
Examine the blade guard for damages or cracks.
Replace the blade guard if it has been hit or if it has
cracks. Do not use the product without a guard or a
defective guard.
22 757 - 003 - 24.06.2020
22


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Husqvarna 520iRX at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Husqvarna 520iRX in the language / languages: English as an attachment in your email.

The manual is 2,26 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Husqvarna 520iRX

Husqvarna 520iRX User Manual - German, Dutch, French - 108 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info