35212
23
Zoom out
Zoom in
Previous page
1/32
Next page
23
HOW TO SEW BUTTONHOLES
Preparation
Select buttonhole with the stitch Selection dial.
Snap on The buttonhole foot.
Adjust the stitch length dial between “0.5” - “1”.
The density of the stitch depends on thickness of the fabric.
Note: Always test sew a buttonhole.
To prepare the fabric
Measure the diameter of the button and add 0.3 cm (1/8”) for the
bartacks. If you have a very thick button, add more to the diameter
measurement. Mark the position and length of the buttonhole on the
fabric. Position the fabric so that the needle is on the mark that is
furthest from you. Pull the buttonhole foot towards you as far as it
will go.
Lower the foot.
1. Select buttonhole with the stitch selection dial. Turn the stitch
selection dial to (1) “
“. Sew at moderate speed until you reach
the end mark.
2. Turn the stitch selection dial to (2, 4)“
“ and sew 5-6 bartack
stitches.
3. Turn the stitch selection dial to (3) “
“ and sew the left side of
the buttonhole to the mark at the end which is further from you.
4. Turn the stitch selection dial to (2, 4) “
“ and sew bar tack
stitches.
Remove the fabric from under the foot. Pull the upper thread to the
wrong side of the fabric and knot upper and lower threads. Cut the
center of the buttonhole with the seam ripper, being careful not to
cut the stitches on either side.
Stitch length dial
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Huskystar E10 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Huskystar E10 in the language / languages: English as an attachment in your email.

The manual is 0,84 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Huskystar E10

Huskystar E10 User Manual - Dutch - 32 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info