35212
16
Zoom out
Zoom in
Previous page
1/32
Next page
16
THREADING THE UPPER THREAD
Threading is simple but it is important to thread correctly to prevent
sewing problems could result.
- Start by raising the needle to its highest point (1), and also raise
the presser foot to release the tension discs. (2)
Attention:
For safety, it is strongly suggested you turn off the power before threading.
- Lift up the spool pin. Place the spool of thread on the holder
with the thread coming off the spool as shown. For small thread
spools, place small side of spool holder next to spool. (3)
- Draw thread from spool through the upper thread guide. (4)
- Guide thread around thread guide (5) pulling thread through pre-
tension spring as illustrated.
- Thread tension disks by leading thread down in right channel
and up in left channel (6). During this process it is helpful to hold
the thread between the spool and thread guide (4).
- At the top pull thread from right to left through the slotted eye of
the take-up lever and then down again. (7)
- Place thread behind the thin wire needle clamp guide (8) and
then down to the needle eye and thread from front to back.
- Pull about 6-8 inches of thread under the presser foot to the
back. Trim thread to length with built in thread cutter. (9)
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Huskystar E10 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Huskystar E10 in the language / languages: English as an attachment in your email.

The manual is 0,84 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Huskystar E10

Huskystar E10 User Manual - Dutch - 32 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info