474380
25
Zoom out
Zoom in
Previous page
1/40
Next page
23
Tape the button over the placement mark. A
pin can be taped on top of the foot to form a
shank.
- Set the pattern selector at " 2 " for Model 207.
- Set the pattern selector at " 0 " for Model 215.
Align both holes of the button with the slot of
the foot and place the left hole of the button
just below the needle point.
Lower the foot.
- Turn the Pattern Selector Dial for Model 207,
- Turn the Stitch Width Dial for Model 215,
until the needle point comes just above the
right hole of the button.
Sew about fi ve stitches and raise the needle.
To strengthen the shank, cut the threads leaving
a 20 cm (8') tail. Bring the needle thread down
through the hole in the button and wind it
around the shank. Draw the thread to the
wrong side and knot.
Note: When sewing the button is complete, raise the feed
teeth.
1
2
3
4
5
0
Stitch selector: 3 Stitch length: Set at any number (no fi xed setting)
Stitch width: Adjust the stitch width to match the holes on the button. (Model 215 only)
Presser foot: Zigzag foot Thread tension:4 - 6 Feed teeth: Dropped (See page 16.)
Sewing Buttons
1/2
3
4
5
6
7
8
1
4
2
3
0
1
2
3
4
8
1
1
2
3
4
5
6
1
2
3
4
5
6
25


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Huskystar 215 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Huskystar 215 in the language / languages: English as an attachment in your email.

The manual is 0,53 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info