474380
13
Zoom out
Zoom in
Previous page
1/40
Next page
11
2
4
Threading the Machine
Switch off the main switch.
Raise the take-up lever to its highest
position by turning the handwheel toward
you. Raise the presser foot. Place the spool
on the spool pin as shown, with the thread
coming from the back of the spool.
1 Draw the thread into the thread guide
using both hands.
2 While holding the thread near the spool,
draw it down into the tension area and
then around the check spring holder.
3 Firmly draw the thread up and through
the take-up lever from right to left.
4 Then, draw the thread down and slip it
into the lower thread guide.
5 Draw the thread down and slip it into
the needle bar thread guide.
6 Thread the needle eye from front to
back.
NOTE: You may want to cut the end of the thread
with sharp scissors for easier needle threading.
2
4
5
6
1
3
5
1
3
6
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Huskystar 215 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Huskystar 215 in the language / languages: English as an attachment in your email.

The manual is 0,53 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info