Menu Description Settings
Feedback Slack Sets the allowable
tolerance or dead
band before the
system will respond
to changes in
feedback. Reduces
servo jitter or chatter.
.5° to 3.0°
Where .5 = tighter response to
rudder feedback, and 3.0 =
looser response to rudder
feedback.
Default: .7°
Feedback 0
Position
Adjusts the zero (0)
position of the rudder
when there is a
dierence between
the actual rudder
position and the
readout on the
display. Make sure
the rudder is in the
center position before
you change this
setting.
-7.5° to 7.5°
(where -7.5 = Port and
+7.5 = Starboard)
Default: 0°
Feedback Type Sets the rudder
feedback type
connected to the
autopilot. The
Gyronav sensor must
be connected and
enabled (see
Gyronav).
Disabled: O
FB30
LF n: Linear Normal
LF r: Linear Reverse
POT n: Potentiometer Normal
POT r: Potentiometer Reverse
LIN: Linear
Default: FB30
Power Steering
Type
Sets the type of the
power steering
actuator installed on
the vessel. Pump
should be matched to
steering cylinder size.
Rev 2 and Rev 3
settings attenuate
controller voltage
output.
SOL: Solenoids
(valve actuators)
REV 1: Pump is well matched
to steering cylinder (100%
controller voltage output)
REV 2: Oversized pump (80%
controller voltage output)
REV 3: Grossly oversized
pump (60% controller voltage
output)
RELAYS: Signal level outputs
for interfacing with vessel
steering systems.
