Manual Humminbird PiranhaMax 150 (page 25 of 52) (English)

522296

Zoom out

Zoom in

1/52

NOTE: It is often necessary to make several incremental transducer adjustments

before optimum high speed performance is achieved. Due to the wide variety of boat

hulls, however, it is not always possible to obtain high speed depth readings.

6. Once you have reached a consistently good sonar signal at the desired

speeds, you are ready to lock down the transducer settings. Remove the

transducer from the bracket (after noting where the ratchets are

assembled), then re-align the mounting bracket against the transom of the

boat to match the traced silhouette. Check the bracket position with the

level again to make sure it is still level, then mark the third mounting hole

using a pencil or marker. Unscrew and remove the mounting screws and

the transducer bracket and set aside.

7. Drill the third mounting hole, using a 5/32” drill bit. Use a marine-grade

silicone sealant to fill all three drilled mounting holes, especially if the

holes penetrated the transom wall.

NOTE: On fiberglass hulls, it is best to use progressively larger drill bits to reduce the

chance of chipping or flaking the outer coating.

8. Re-position the transducer bracket against

the transom of the boat, then hand-install

all three screws. Make sure that the

transducer location has not changed, then

fully tighten all three mounting screws

(Figure 27). Hand tighten only! Re-install

the transducer to the mounting bracket,

making sure to assemble the ratchets in the

same location they had before. (See Figures

18a - 18d and Figure 21 - 22). If you have

performed the preceding procedures

correctly, the transducer should be level

and at the right height for optimal operation.

Fully Tighten All Three

Mounting Screws

Figure 27

Transom Transducer Installation

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Humminbird PiranhaMax 150 in the language / languages: English as an attachment in your email.

The manual is 1,11 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Humminbird PiranhaMax 150 Manual

Product: