522349
147
Zoom out
Zoom in
Previous page
1/160
Next page
137
Display Problems
There are several main conditions or sources of possible interference that may cause problems with the quality of the information displayed on the control head.
Look in the following table for some symptoms of display problems and possible solutions:
Problem Possible Cause
The control head loses power at high
speeds.
When the boat moves at higher speeds,
the bottom disappears or suddenly
weakens, or the display contains gaps.
There are no fish detected, even when
you know they are in the water under
the boat, or sonar readings seem weak
or faulty.
If the power output of your boat’s engine is unregulated, the control head may be protecting itself using
its over-voltage protection feature. Make sure the input voltage does not exceed 20 Volts.
The transducer position may need to be adjusted. A mix of air and water flowing around the transducer
(cavitation) may be interfering with the interpretation of sonar data. See your Installation Guide for
suggestions on adjusting the transducer position.
Electrical noise from the boat’s engine may be interfering with sonar reception. See Finding the Cause
of Noise for more information.
Sonar readings may be affected if the transducer is not positioned correctly (i.e. mounted at an angle,
not straight down), or there is some kind of mechanical interference, either because it is mounted inside
a hull that is too thick for proper sonar transmission, the bond between the transducer and the hull is
not airtight, or because the transducer is dirty. Check with your Installation Guide for guidance on re-
positioning the transducer, and make sure the transducer is clean.
Low battery voltage may be affecting the power of signal transmission.
Electrical noise from the boats engine may be interfering with sonar reception. See Finding the Cause
of Noise for more information.
Troubleshooting
147


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Humminbird 998C SI at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Humminbird 998C SI in the language / languages: English as an attachment in your email.

The manual is 12,13 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info