60811
16
Zoom out
Zoom in
Previous page
1/133
Next page
GB15
User’s Manual
This chapter describes how to connect your product to the TV with the particular equipments for gaining
optimum signal quality. The product provides various interfaces to connect to the TV, VCR or other
devices. Select the most appropriate procedure depending on the equipment you have.
Note: If you encounter any problems setting up your product, please contact your local product
distributor.
2.1 Connecting the Antenna
You can select one of the following antenna connections depending on the equipment you have. The
product has two antenna modes according to setting.
1. Loop Through
1. Connect the antenna cable to LNB 1 IN.
2. Connect the other cable from LNB 1 OUT to LNB 2 IN.
Note:
Connect to LNB 1 IN when using the motor antenna, SCD
Antenna (also known as Unicable or SATCR) or SMATV
antenna.
You can switch channels while recording if the channels
share the same polarity. However, you cannot switch to a
channel with a di erent polarity from the channel being
recorded.
2. Two Separate Antennas Setting
Connect the two antenna cables providing di erent
broadcasting signals to your product. You can con gure LNB 1
IN and LNB 2 IN independently.
2. Setup
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Humax ICORD HD at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Humax ICORD HD in the language / languages: English as an attachment in your email.

The manual is 6,3 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info