Manual HUMANTECHNIK A-2466-0 (page 10 of 40) (English, German, Dutch, French, Italian, Spanish)

565067

Zoom out

Zoom in

1/40

English 10

selector switch, which is located

towards the top of the battery com-

partment, to the required channel

number.

All transmitters and receivers must be

set to the same channel.

Fig.: Plug in the microphone cable

and stick the microphone over the

acoustic output cover of your door-

bell.

4. Setting the sensitivity

Set the sensitivity controller to its lowest

level (turn to the anticlockwise stop).

Activate the doorbell and gradually in-

crease the sensitivity of the transmitter

(by turning the dial clockwise) until the

transmitter reacts to the doorbell.

If your intercom system operates with

different signal tones, make sure that

both signal tones are reliably detec-

ted.

5. Setting the type of signal

You can select one of the two signal

types on the right-hand side of the ra-

dio doorbell transmitter acoustic. Use

the stylus that comes included with

the device to push the signal selec-

tion switch to the desired setting.

Doorbell 1

To indicate a signal from Door-

bell 1, set the signal selection switch

to the top position. This will send the

Doorbell 1 signal to all the receivers

that are switched on and set to the

same channel.

Fig. setting the correct radio channel.

3. Installing the microphone cable

Use the adhesive ring to glue the mi-

crophone to the sound outlet of your

doorbell/intercom system and plug

the microphone cable into the con-

nection jack on the bottom of the radio

doorbell transmitter acoustic.

To do this, pull off the backing foil from

the adhesive ring on the microphone.

For optimum function of the trans-

mitter, its sensitivity dial switch must

be set so the transmitter reliably res-

ponds to the doorbell.

Pulling off the backing foil.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of HUMANTECHNIK A-2466-0 in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 0,69 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

HUMANTECHNIK A-2466-0 Manual

Product: