565086
14
Zoom out
Zoom in
Previous page
1/52
Next page
Mains operation
You can also operate your
RF blink
lamp
via the plug-in power supply
unit. To connect the PSU, insert the
connector on the end of the PSU
cable into the corresponding socket
on the left-hand side of the device.
Then plug the power supply unit into
the normal 230 V socket in your
house.
Recharging the A-2995-0 recharge-
able battery
If there is a rechargeable battery in
the
RF blink lamp
while the lamp is
plugged into a power supply, the bat-
tery will be recharged.
The recharging cycle begins automa-
tically. After 12 hours, the device will
switch to conservation charging. The
device can remain plugged into the
regular power supply. The
lisa
devi-
ce’s reception functions will continue
to operate while recharging is in pro-
gress.
14 English
Battery/rechargeable battery empty
If the »
battery/rechargeable battery
empty-display
«
lights up constantly,
this means that the battery or rechar-
geable battery used is almost fully
discharged. A regular battery must
be replaced or a rechargeable bat-
tery recharged.
The »battery/rechargeable battery
empty-display
«
might flash briefly in
the flashing mode; this does not indi-
cate that the battery is low.
Acoustic alarm
The acoustic alarm can be switched
on or off using the on/off button.
Reset button
Press the reset button to acknowled-
ge incoming signals. This will switch
off the flashing light and the acoustic
signal.
Retrieving the last signal
The
RF blink lamp
stores any signal it
has received for approx. 3 minutes.
During this time, you can repeat the
signal by pressing the reset button
again. The signal will then be indica-
ted by the signal lights. The flashing
light and the acoustic signal will not
be repeated.
Funkblinklampe_1108:BA_Akku_Funkblinklamp_D 24.11.2008 13:37 S
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for HUMANTECHNIK A-2415-0 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of HUMANTECHNIK A-2415-0 in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 0,26 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info