500673
16
Zoom out
Zoom in
Previous page
1/40
Next page
16 AUTOMATIC CHARGER
Cables or leads connecting the device or connecting components within the
device should be examined thoroughly for faults in the insulation.
If a fault in the cables of the device is found, the device should immediately be
removed from service until the defective cables have been replaced.
If the following manual does not fully describe function and safety precautions
to a layman, or if the technical appliance is not clear, or if it is unclear which
external devices may be attached and how to attach them, then it is vital to
contact a specialist for advice. Before mounting this device and connecting the
accessories, make sure, that this device is suitable for the intended use.
If there is any case of doubt or there are any questions, please contact specialists,
experts or the manufacturers of the modules and components. Please note, that
operating and connection errors are beyond our influence and that we cannot
maintain warranty or be made liable for damages occurring thereof.
This item was tested and manufactured according to EMVG (EG Directive
89/336/EWG/ Electromagnetic Compatibility) and holds the corresponding
CE approval. Any change of the circuitry or exchange of components other
than specified will make this approval invalid.
The device may be used for the described purpose, if these operating
instructions are observed.
Do not operate the device during frost or danger of frost to avoid the formation
of condensation water.
Do not expose the device to rain or moisture to avoid a fire hazard and the
danger of an electric shock.
Do not allow liquids of any kind to penetrate into the device.
Never cover the ventilation slots or housing.
Do not place the device near to warm air sources such as heaters or the
like!
Never put or lead the charging cable near to inflammable materials. The
charging cable may neither be kinked nor be led over sharp-edged parts.
Live cables or lines, which are connected to the device, must always be tested
before and after use for insulation faults or breakages.
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for HTronic AL 600plus at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of HTronic AL 600plus in the language / languages: German as an attachment in your email.

The manual is 0,81 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info