617377
90
Zoom out
Zoom in
Previous page
1/134
Next page
To clean the area around the ink nozzles
1. Turn on the HP All-in-One and open the print-carriage access door.
The print carriage moves to the far right side of the HP All-in-One.
2. Wait until the print carriage is idle and silent, and then unplug the power cord
from the back of the HP All-in-One.
3. Lightly press down on the print cartridge to release it, and then pull it toward you
out of the slot.
Note Do not remove both print cartridges at the same time. Remove and
clean each print cartridge one at a time. Do not leave a print cartridge
outside the HP All-in-One for more than 30 minutes.
4. Place the print cartridge on a piece of paper with the ink nozzles facing up.
5. Lightly moisten a clean foam rubber swab with distilled water.
6. Clean the face and edges around the ink nozzle area with the swab, as shown
below.
1 Nozzle plate (do not clean)
2 Face and edges around the ink nozzle area
Warning Do not clean the nozzle plate.
7. Allow the ink nozzle area to dry for approximately ten minutes.
8. Slide the print cartridge back into the slot. Push the print cartridge forward until it
clicks into place.
9. Repeat if necessary for the other print cartridge.
10. Gently close the print-carriage access door and plug the power cord into the back
of the HP All-in-One.
Change the device settings
You can change the scroll speed and prompt delay time settings on your HP All-in-
One so that it behaves according to your preference. You can also restore the device
settings to what they were when you purchased your device. This will erase any new
defaults you have set.
Set the scroll speed
The Scroll Speed option lets you control the rate that text messages scroll in the
control panel display. For example, if the message is "Load paper, then press OK.",
User Guide 87
Maintain your HP All-in-One
90


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for HP PSC 1613 All-in-One at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of HP PSC 1613 All-in-One in the language / languages: English as an attachment in your email.

The manual is 4,18 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of HP PSC 1613 All-in-One

HP PSC 1613 All-in-One User Manual - German - 152 pages

HP PSC 1613 All-in-One User Manual - Dutch - 150 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info