480836
40
Zoom out
Zoom in
Previous page
1/64
Next page
Hardware setup troubleshooting
Use this section to solve any problems you might encounter while setting up the HP All-in-One
hardware.
My HP All-in-One does not turn on
Solution Make sure the power cord is firmly connected, and wait a few seconds for the
HP All-in-One to turn on. Also, if the HP All-in-One is plugged in to a power strip, make sure
the power strip is turned on.
My USB cable is not connected
Solution Do not plug in the USB cable before being prompted during software
installation. Connecting the USB cable before prompting can cause errors. Plug one end of
the USB cable into your computer and the other into the back of the HP All-in-One. You can
connect to any USB port on the computer (not a keyboard or accessory).
I have light or message about print cartridge or alignment problems
Cause The incorrect type of paper is loaded in the paper tray.
Solution The paper must be blank and white for the alignment to succeed.
If the alignment fails again, you might have a defective sensor or print cartridge. Contact HP
Support by going to www.hp.com/support. Click Contact HP for information on calling for
technical support.
Cause Protective tape is covering the print cartridges.
Solution Gently remove the plastic tape by using the pink pull tab. Do not touch the ink
nozzles or the copper-colored contacts.
Chapter 9
36 HP PSC 1400 All-in-One series
Troubleshooting information
40


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for HP PSC 1400 All-in-One series at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of HP PSC 1400 All-in-One series in the language / languages: English as an attachment in your email.

The manual is 4,09 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of HP PSC 1400 All-in-One series

HP PSC 1400 All-in-One series User Manual - German - 68 pages

HP PSC 1400 All-in-One series Installation Guide - Dutch - 12 pages

HP PSC 1400 All-in-One series User Manual - Dutch - 66 pages

HP PSC 1400 All-in-One series Installation Guide - French - 12 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info