678998

HP Pre 3 Manual

227
Zoom out
Zoom in
Previous page
1/234
Next page
D : Regulatory and safety information 227
D Regulatory and safety information
This section contains the legal notices required by the regulatory bodies of your country.
United States (Product with FCC ID & FCC logo)
Federal Communications Commission Notice
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference with one or more of the following measures:
• Reorient or relocate the receiving aerial.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio or television technician for help.
Modifications
The FCC requires the user to be notified that any changes or modifications made to this
device that are not expressly approved by HP may void the user’s authority to operate the
equipment.
The FCC has granted an Equipment Authorisation for this model device with all reported
SAR levels evaluated as in compliance with the FCC RF exposure guidelines. SAR
information on this model device is on file with the FCC and can be found under the Display
Grant section of fcc.gov/oet/ea/fccid after searching for FCC ID B94HHF30CE.
Declaration of Conformity for Products Marked with the FCC Logo (United
States Only)
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
• This device may not cause harmful interference.
• This device must accept any interference received, including interference that may cause
undesired operation.
If you have questions about the product or this FCC declaration, write to:
Hewlett-Packard Company, 950 W. Maude Ave, Sunnyvale, Ca. 94085
For questions regarding this FCC declaration, call HP at 1-281-514-3333. For general
questions about the product, call 1-800-HP-INVENT (1-800-474-6836).
To identify your product, refer to the part, series or model number located on the product.
Cables
To maintain compliance with FCC Rules and Regulations, connections to this device must be
made with shielded cables having metallic RFI/EMI connector hoods.
WARNING! Exposure to Radio Frequency (RF) Radiation: The radiated output
power of this device is below the FCC radio frequency exposure limits.
Nevertheless, the device should be used in such a manner that the potential for
human contact during normal operation is minimised.
The exposure standard for wireless mobile device employs a unit of measurement known as
the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6 W/Kg. Tests for
SAR are conducted using standard operating positions accepted by the FCC with the device
transmitting at its highest certified power level in all tested frequency bands. Although the
SAR is determined at the highest certified power level, the actual SAR level of the device
while operating can be well below the maximum value. This is because the device is
designed to operate at multiple power levels so as to use only the power required to reach
the network. In general, the closer you are to a wireless base station antenna, the lower the
power output. To avoid the possibility of exceeding the FCC radio frequency exposure limits,
human proximity to the antenna should be minimised. No metallic body accessories are
allowed and a 1.5 cm space between this device and the body must be maintained to
… 227 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for HP Pre 3 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of HP Pre 3 in the language / languages: English as an attachment in your email.

The manual is 2,43 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of HP Pre 3

HP Pre 3 User Manual - German - 266 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info