655091
89
Zoom out
Zoom in
Previous page
1/136
Next page
hear noise, turn o your DSL modem and completely remove power for at least 15 minutes. Turn the
DSL modem back on and listen to the dial tone again.
NOTE: You might notice static on the phone line again in the future. If the printer stops sending and
receiving faxes, repeat this process.
If the phone line is still noisy, contact your telephone company. For information on turning your DSL
modem o, contact your DSL provider for support.
If you are using a phone splitter, this can cause faxing problems. (A splitter is a two-cord connector that
plugs into a telephone wall jack.) Try removing the splitter and connecting the printer directly to the
telephone wall jack.
The printer cannot receive faxes, but can send faxes
If you are not using a distinctive ring service, check to make sure that the Distinctive Ring feature on the
printer is set to All Rings . For more information, see Change the answer ring pattern for distinctive ring
on page 38.
If Auto Answer is set to O , you need to receive faxes manually; otherwise, the printer cannot receive
the fax. For information on receiving faxes manually, see Receive a fax manually on page 31.
If you have a voice mail service at the same phone number you use for fax calls, you must receive faxes
manually, not automatically. This means that you must be available to respond in person to incoming
fax calls. Learn more about setting up the printer when you have a voice mail service, click here to go
online for more information. For information on receiving faxes manually, see Receive a fax manually
on page 31.
If you have a computer dial-up modem on the same phone line with the printer, check to make sure that
the software that came with your modem is not set to receive faxes automatically. Modems that are set
up to receive faxes automatically take over the phone line to receive all incoming faxes, which prevents
the printer from receiving fax calls.
If you have an answering machine on the same phone line with the printer, you might have one of the
following problems:
Your answering machine might not be set up correctly with the printer.
Your outgoing message might be too long or too loud to allow the printer to detect fax tones, and
the sending fax machine might disconnect.
Your answering machine might not have enough quiet time after your outgoing message to allow
the printer to detect fax tones. This problem is most common with digital answering machines.
The following actions might help solve these problems:
When you have an answering machine on the same phone line you use for fax calls, try connecting
the answering machine directly to the printer, click here to go online for more information.
Make sure the printer is set to receive faxes automatically. For information on setting up the
printer to receive faxes automatically, see Receive a fax on page 31.
Make sure the Rings to Answer setting is set to a greater number of rings than the answering
machine. For more information, see Set the number of rings before answering on page 38.
Disconnect the answering machine and then try receiving a fax. If faxing is successful without the
answering machine, the answering machine might be causing the problem.
Reconnect the answering machine and record your outgoing message again. Record a message
that is approximately 10 seconds in duration. Speak slowly and at a low volume when recording
ENWW Fax issues 83
89


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for HP OfficeJet 4656 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of HP OfficeJet 4656 in the language / languages: English as an attachment in your email.

The manual is 2,66 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of HP OfficeJet 4656

HP OfficeJet 4656 User Manual - German - 146 pages

HP OfficeJet 4656 User Manual - Dutch - 146 pages

HP OfficeJet 4656 Quick start guide - All languages - 70 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info