20164
18
Zoom out
Zoom in
Previous page
1/198
Next page
2-4 ENWW
Setting up the printer
To set up the printer, complete the following steps. For illustrated setup
information, see the setup poster.
Step 1: Set up the printer
1 Select a location for the printer that is level, sturdy, and can support
all corners of the printer, such as a low table. The location should
be about 25 cm (10 inches) away from a wall to provide easy
access to the rear of the printer for using Tray 1.
2 If your printer was shipped with Tray 3 or you purchased Tray 3 as
an optional accessory, unpack Tray 3. Otherwise, go on to step 3.
a Position Tray 3 in the location where you want to place
the printer.
b Remove the tape and packing materials from Tray 3, including
the foam block located inside the tray.
3 Two people should lift the printer. Each person should grasp the
printer in the front just under the lip below the LCD control panel,
and in the rear by the indentation on either side of Tray 1.
Alternately, each person can hold on to the bottom of the printer
during lifting.
WARNING! It is strongly recommended that two people lift or move the printer.
The printer is top-heavy and can tip if lifted by only one person.
The side of the printer that holds the ink cartridges and printheads
is considerably heavier than the other side.
WARNING! Do not attempt to move the printer by holding on to Tray 2 in the
front or Tray 1 in the back. This can damage the printer and might
cause you to lose your grip on the printer.
4 Move the printer to the prepared location. Be sure that the foam
packing cushions are removed from the bottom of the printer.
Gently place the printer on the prepared location.
-Or-
If installing Tray 3, align the front edge of the printer with the
front edge of the Tray 3 base. Gently lower the printer onto the
Tray 3 base.
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for HP INKJET3000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of HP INKJET3000 in the language / languages: English as an attachment in your email.

The manual is 3,31 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info