20128
74
Zoom out
Zoom in
Previous page
1/82
Next page
67
D
Frequently Asked Questions About
USB (Universal Serial Bus)
Note: If you are a Windows 2000 Professional user, visit HP’s web site at
http://www.hp.com/cposupport/eschome.html for more information.
What is the problem? Possible cause To solve the problem…
During installation,
when I connect a USB cable
between the printer and my
computer, the “New
Hardware Wizard” message
did not appear.
You may not be using
Windows 98.
Make sure Windows 98 is running and your computer
is connected using a USB cable. If you do not have
Windows 98, you need to use a parallel cable.
You may not have USB
enabled.
1 In Windows 98, click Start Settings Control
Panel.
2 Double-click the System icon.
3 Click the Device Manager tab.
4 Click the plus ( + ) icon next to the Universal Serial
Bus Controller option. If you see a USB host
controller and a USB root hub listed, USB is
probably enabled. If you do not see these devices
listed, refer to your computer’s documentation or
contact the manufacturer for more information
on enabling and setting up USB.
5 If you cannot enable USB, you can always use a
parallel cable to connect your printer to your
computer.
Your USB cable may not
be connected properly.
1 Disconnect and then reconnect the USB cable
from your printer.
2 Make sure that it is securely attached.
During installation,
when I connect a USB cable
between the printer and my
computer, an “Unknown
device” message appears.
Static electricity has
built up in the cable
between your
computer and printer.
OR
You may have a
defective USB cable.
1 Disconnect the USB cable from your printer.
2 Unplug the printer from its power cable.
3 Wait approximately 30 seconds.
4 Plug the power back into the printer.
5 Plug the USB cable back into the printer.
6 If “Unknown device” continues to appear in the
“New hardware found” dialog, replace the USB
cable or use a parallel cable.
970C.book Page 67 Tuesday, February 1, 2000 11:31 PM
74


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for HP DESKJET970C at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of HP DESKJET970C in the language / languages: English as an attachment in your email.

The manual is 2,46 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info