1
GENERAL INFORMATION
- This product meets the requirements of Pollution Degree 4
and therefore can be used in exposed weather conditions.
- This product is not suitable for supplying drinking water.
- Threaded water connections are suitable for hand tightening
only.
- This product should only be fitted to a mains water supply.
-
Please follow the instructions to make sure that you get the most
from your timer for simple and efficient watering.
INSTALLING THE BATTERIES
You must use Alkaline batteries - alternatives will result in
incorrect operation.
1. Remove screws and back cover.
2. Insert two 1.5V ‘C’ Alkaline batteries. (Check + and - are
correct.). IMPORTANT: Rechargeable batteries must not be used.
3. Replace batteries each season. (max 12 months use)
MAINTAINING THE WATERPROOF SEAL
1. Ensure that rubber seal is positioned correctly.
2. Replace back cover and screw down tightly.
3. Repeat each time back cover is removed.
HOW TO PROGRAMME THE TIMER
There are two watering operations - Automatic and Manual.
AUTOMATIC OPERATION
1. Set the current time
Turn dial to the nearest hour on the Red scale (24 hour clock)
then press the button. An audible beep confirms correct
setting.
2. Set the watering start time
Turn dial to the nearest hour to your desired start time on the
Red scale (24 hour clock) then press the S button. An audible
beep confirms correct setting.
3. Set the watering frequency
This can be set in hours (every 6, 8, 12, or 24 hours) or it can be
set in days (every 2, 3 or 7 days). Turn dial to desired setting on
the Green scale and then press the Green button. An audible
beep confirms correct setting.
4. Set the watering duration
Turn dial to number of watering minutes required on the Blue
scale and then press the Blue button. An audible beep confirms
GB