513484

Hotpoint TCD G51 XB Manual

20
Zoom out
Zoom in
Previous page
1/36
Next page
GB
Important Information
Condenser Unit...
! You MUST clean the fluff from the condenser EVERY
month.
! Failure to clean the condenser could cause premature
failure of your dryer.
●
Check that:
- The positioning arrows are pointing upwards.
- The 3 clips are re-secured back into their ‘lock’ position.
Product Data... (EU Regulation 392/2012)
Rated capacity of Cotton laundry for the standard programme at full load 8 kg Energy efficiency class B
The weighted Annual Energy Consumption (AE
c
) 559.8 kWh
Consumption per year, based on 160 drying cycles of the standard cotton programme at full and partial load, and the
consumption of the low-power modes. Actual energy consumption per cycle will depend on how the appliance is used.
This household tumble dryer is an Automatic Condenser Dryer
Energy consumption : full load E
dry
4.77 kWh, partial load E
dry1/2
2.53 kWh
Power consumption : off-mode (P
o
) 0.14 W, left-on mode (P
l
) 3.16 W
Duration of the ‘left-on mode’ for power management systems 30 minutes
The ‘standard cotton programme’ suitable for drying normal wet cotton laundry that is the most efficient programme in terms
of energy consumption for cotton used at full and partial load is Cottons - Cupboard Dry
Programme time (minutes) : weighted (T
t
) full & partial load 104, full load (T
dry
) 139, partial load (T
dry1/2
) 78
Condensation efficiency class B
Average condensation efficiency (%) : full load (C
dry
) 82, partial load (C
dry1/2
) 80, weighted (C
t
) full & partial load 81
Airborne acoustical noise emissions 68 dB(A) re 1 pW
This data is also available on the website http://www
.hotpoint-ariston.com/ha/
STEP 1.
Open the condenser cover
- hold the handle and
pull towards you.
STEP 2.
Remove the condenser by
rotating the 3 clips then
pulling the condenser
towards you.
(There may be some water
in the tubes, this is normal).
STEP 3.
Flush the condenser, from
the rear with water, to
remove any fluff deposits.
STEP 4.
Refit the condenser unit
- ensure that the unit is
pushed in fully, all 3 clips
are re-secured and the
positiong arrows on the
front of the condenser are
pointing upwards.
Rotate 3 clips
20
… 20 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hotpoint TCD G51 XB at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hotpoint TCD G51 XB in the language / languages: English, French as an attachment in your email.

The manual is 1,45 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Hotpoint TCD G51 XB

Hotpoint TCD G51 XB User Manual - English, Portuguese, Spanish - 52 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info