Manual Hotpoint Quadrio 4D SB HA (page 25 of 64) (English, German, Dutch, French, Italian, Polish, Portuguese, Spanish)

510699

Zoom out

Zoom in

1/64

temperature must be set to the minimum value in order to

preserve the food.

To enable the function:

set the REFRIGERATOR OPERATION knob on

A double acoustic signal informs you when it has been enabled.

A single acoustic signal informs you when it has been disabled.

Optimization Energy Saving function

The “Optimization Energy Saving” function may be activated in

order to optimise energy consumption while maintaining the

cooling performance of the product. This function maximises the

energy saved. It is activated by setting the knobs to “I CARE”,

then pressing and holding the Super Freeze button for at least 3

seconds; the Super Freeze indicator light will begin to flash,

signalling the activation of this function.

The “Optimization Energy Saving” function may also be

deactivated by pressing the Super Freeze button again. The

corresponding indicator light will stop flashing, thereby signalling

that the original operating conditions have been restored.

In humid environments, when the “Optimization Energy

Saving” function is activated, slight condensation may form on

the door of the appliance; normal operating conditions are

restored when the function is deactivated.

Replacing the light bulb

To replace the light bulb in the refrigerator compartment, pull out

the plug from the electrical socket. Follow the instructions below.

Access the light bulb by removing the cover as indicated in the

diagram.

Replace it with a similar light bulb within the power range

indicated on the cover (10 W, 15 W or 25 W).

Precautions and tips

! The appliance was designed and manufactured in compliance

with international safety standards. The following warnings are

provided for safety reasons and must be read carefully.

This appliance complies with the following Community Directives:

- 73/23/EEC of 19/02/73 (Low Voltage) and subsequent

amendments;

-89/336/EEC of 03.05.89 (Electromagnetic Compatibility) and

subsequent amendments;

- 2002/96/CE..

General safety

• The appliance was designed for domestic use inside the

home and is not intended for commercial or industrial use.

• The appliance must be used to store and freeze food products

by adults only and according to the instructions in this manual.

• The appliance must not be installed outdoors, even in

covered areas. It is extremely dangerous to leave the

appliance exposed to rain and storms.

• Do not touch the appliance with bare feet or with wet or moist

hands and feet.

• Do not touch the internal cooling elements: this could cause

skin abrasions or frost/freezer burns.

• When unplugging the appliance always pull the plug from the

mains socket, do not pull on the cable.

• Before cleaning and maintenance, always switch off the

appliance and disconnect it from the electrical supply. It is not

sufficient to set the temperature adjustment knobs on OFF

(appliance off) to eliminate all electrical contact.

• In the case of a malfunction, under no circumstances should

you attempt to repair the appliance yourself. Repairs carried

out by inexperienced persons may cause injury or further

malfunctioning of the appliance.

• Do not use any sharp or pointed utensils or electrical

equipment - other than the type recommended by the

manufacturer - inside the frozen food storage compartments.

• Do not put ice cubes taken directly from the freezer into your

mouth.

• This appliance is not intended for use by persons (including

children) with reduced physical, sensory or lack of experience

and knowledge unless they have been given supervision or

instruction concerning use of the appliance by a person

responsible for their safety. Children should be supervised to

ensure that they do not play with the appliance.

• Keep packaging material out of the reach of children! It can

become a choking or suffocation hazard.

• When closing the refrigerator doors, pay attention to the

position of the upright (see figure).

• Make sure that excessive volumes of food are not placed in

the upper part of the freezer compartment, in the space

reserved for the ice tray (where present).

Disposal

• Observe local environmental standards when disposing

packaging material for recycling purposes.

• The European Directive 2002/96/EC on Waste Electrical and

Electronic Equipment (WEEE), requires that old household

electrical appliances must not be disposed of in the normal

unsorted municipal waste stream. Old appliances must be

collected separately in order to optimise the recovery and

recycling of the materials they contain and reduce the impact

on human health and the environment.

The crossed out “wheeled bin” symbol on the product

reminds you of your obligation, that when you dispose of the

appliance it must be separately collected. Consumers should

contact their local authority or retailer for information

concerning the correct disposal of their old appliance.

Respecting and conserving the environment

• Install the appliance in a fresh and well-ventilated room.

Ensure that it is protected from direct sunlight and do not

place it near heat sources.

• Try to avoid keeping the door open for long periods or

opening the door too frequently in order to conserve energy.

• Do not fill the appliance with too much food: cold air must

circulate freely for food to be preserved properly. If circulation

is impeded, the compressor will work continuously.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Hotpoint Quadrio 4D SB HA in the language / languages: English, German, Dutch, French, Italian, Polish, Portuguese, Spanish as an attachment in your email.

The manual is 3,76 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Hotpoint Quadrio 4D SB HA Manual

Product: