Manual Hotpoint FDFEX 11011 EXTRA (page 11 of 20) (English)

670829

Zoom out

Zoom in

1/20

Start-up and use

Measuring out the detergent

A good wash result also depends on the correct amount of

detergent being used. Exceeding the stated amount does not

result in a more effective wash and increases environmental

pollution.

Based on how soiled the items are, the amount can

be adjusted to individual cases using powder or liquid

detergent.

In the case of normally soiled items, use approximately either

35 gr (powder detergent) or 35 ml (liquid detergent). If tablets

are used, one tablet will be enough.

If the crockery is only lightly soiled or it has been rinsed

with water before being placed in the dishwasher, reduce

the amount of detergent considerably.

For good washing results also follow the instructions shown

on the detergent box. For further questions please ask the

detergent producers' Advice Offices.

If the detergent dispenser is still closed, use the closing

device “A” to open it.

Introduce the detergent into the dry dispenser “B” only.

Place the amount of detergent for pre-washing directly

inside the tub.

1.WhenmeasuringoutthedetergentrefertotheTableofwash

cyclestoaddtheproperquantity.CompartmentB comprises

a level showing the maximum quantity of liquid or powder

detergent that can be added to each cycle.

2.Removedetergentresiduesfromtheedgesofthedispenser

and close the cover until it clicks.

3.Closethelidofthedetergentdispenserbypullingitupuntil

the closing device is secured in place.

The detergent dispenser automatically opens up at the right time

according to the wash cycle.

If all-in-one detergents are used, we recommend using the TABS

option, because it adjusts the cycle so that the best washing

and drying results are always achieved.

Only use detergent which has been specifically designed

for dishwashers.

DO NOT USE washing up liquid.

Using excessive detergent may result in foam residue

remaining in the machine after the cycle has ended.

The use of tablets is only recommended for models which

offer the MULTI-FUNCTIONAL TABLETS option.

To achieve the best results from each washing and drying

cycle, powder detergent, rinse-aid liquid and salt should

be used.

*Onlyavailableinselectedmodels.

Starting the dishwasher

1.Turnthewatertapon.

2.Pressthe ON/OFFbutton: TheON/OFFindicator lightand

the display light up.

3.Openthedoorandpourinasuitableamountofdetergent

(see below).

4. Load the racks

(see Loading the racks)

and shut the door.

5. Select the wash cycle in accordance with the type of crockery

and its soil level

(see Table of wash cycles)

by pressing the

wash-cycle selection buttons.

6. Select the wash options*

(see adjacent information).

7.StartthecyclebypressingtheStart/Pausebutton:Thewash

indicator light comes on and the time left to the end of the cycle

appears on the display.

8. At the end of the cycle, the display shows END. Switch off the

appliancebypressingtheON/OFFbutton,shutoffthewatertap

and unplug the appliance from the electricity socket.

9.Waitforafewminutesbeforeremovingthecrockeryinorder

toavoidburns.Unloadtheracks,beginningwiththelowerlevel.

- The machine will switch off automatically during long

periods of inactivity in order to minimise electricity

consumption.

AUTO WASH CYCLES*:some dishwasher models are

equipped with a special sensor which can be used to assess

the level of soiling and automatically select the most efficient

and economical wash cycle accordingly. The duration of the

auto wash cycles may vary due to the operation of the sensor.

Changing a wash cycle in progress

If a mistake was made in the wash cycle selection process, it is

possible to change the cycle provided that it has only just begun:

once the wash cycle has started, in order to change the wash

cycleswitchoffthemachinebypressingandholdingtheON/

OFF/Resetbutton.Switchitbackonusingthesamebuttonand

select the desired wash cycle and options.

Adding extra crockery

PresstheStart/Pausebuttonandopenthedoor,takingcareto

avoid the escaping steam, and place the crockery inside the

dishwasher.PresstheStart/Pausebutton:Thecyclewillstart

again after a long beep has been emitted.

If the delayed start has been set, at the end of the countdown

the wash cycle will not start. It will stay in Pause mode.

PresstheStart/Pausebuttontopausethemachine;thewash

cycle is stopped.

At this stage it is not possible to change the wash cycle.

Accidental interruptions

If the door is opened during the wash cycle or there is a power

cut, the cycle stops. It starts again from the point at which it

was interrupted once the door has been shut or the electricity

supply is restored.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Hotpoint FDFEX 11011 EXTRA in the language / languages: English as an attachment in your email.

The manual is 2,3 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Hotpoint FDFEX 11011 EXTRA Manual

Product: