665349

Hotpoint-Ariston TVFM 70 Manual

2
Zoom out
Zoom in
Previous page
1/4
Next page
WHERE TO PUT YOUR DRYER
If you are going to install the appliance
under a work counter be sure to leave
a 10mm space between the top and any
other objects on or above the machine
and a 15mm space between the sides
and any kitchen units or walls to ensure
proper air circulation.
The dryer must never be installed
behind a lockable door, a sliding door or
a door with a hinge on the opposite side
to that of the dryer door.
VENTILATION
When the dryer is in use there has to be adequate ventilation
to avoid the back flow of gases into the room from appliances
burning other fuels, including open fires.
The vent tube should not exceed 2.4 metres in length.
The tube should be kept clear of the air intake vent and kinks or
‘U’ bends must be avoided as these will obstruct the tube and trap
condensation.
VENTING
Wall mounting
Keep the tube as short and as straight
as possible to prevent condensation
forming in the vent pipe.
The duct in the wall should slope
slightly downwards.
Window mounting
The hole in the window should be as
low down as possible and the tube
should be kept as short as possible.
Depending on how often you use your tumble dryer, it is
essential that areas A and B are checked periodically to remove
lint or debris.
Open window venting
The end of the tube should be
directed downwards, to prevent
warm moist air from condensing in
the room or dryer.
ELECTRICAL CONNECTIONS
The socket must be grounded. The power supply cord should be
checked periodically and, if required, replaced by a cord specially
prepared for this dryer.
LEVELLING YOUR DRYER
The dryer must be installed level for
correct operation. When you have
installed your dryer in its final location
check that it is first level side to side
and then back to front.
If the dryer is not level use a wooden
block to support it while adjusting the
two front legs up or down until your
dryer is level.
BEFORE YOU START USING YOUR DRYER
Once you have installed your dryer and before you use it clean
the inside of the drum to remove any dust that could have
accumulated during transport.
The HEAT button selects drying temperature.
OUT: LOW heat IN: HIGH heat
10
m
m
15 mm
15 mm
15 mm
15 mm
B
A
Dryer Description
Control panel
Installation
Do not discharge exhaust air into a flue which is used for
exhaust fumes from other appliances that burn gas or other
fuels.
Do not discharge exhaust air into an extraction system or any
duct with an extractor fan. This will affect the way the thermal
controls operate and can result in a fire hazard.
!
Air intake vent
Do not block or obstruct
Caution: Hot!
Vent Tube fitted here
20
30
40
50
60
70
80
100
110
120
130
0
TIMER
Knob
Indicator
HEAT
Button
START
Button
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hotpoint-Ariston TVFM 70 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hotpoint-Ariston TVFM 70 in the language / languages: English as an attachment in your email.

The manual is 0,94 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info