512993
18
Zoom out
Zoom in
Previous page
1/24
Next page
18
EN
Starting the dishwasher
1. Turn the water tap on.
2. Press the ON/OFF button: the display will light up.
3. Measure out the detergent (
see below
).
4. Load the racks (see Loading the racks) and shut
the door.
5. Select the programme by pressing the WASH
CYCLE SELECT button; the corresponding indicator
light will illuminate.
6. Select the wash options (
see below
).
7. Start the cycle by pressing the START/RESET
button: the machine will emit a confirmation beep.
The WASH CYCLE PHASE indicator lights display
the status of the cycle: Pre-wash, Wash, Rinse, or
Drying.
8. At the end of the cycle two short beeps will sound
and the DRYING PHASE indicator light will
flash.Switch off the appliance by pressing the ON/
OFF button, shut off the water tap and unplug the
appliance from the electricity socket.
9. Open the door and wait for a few minutes before
removing the crockery, in order to avoid burns.
Unload the racks, beginning with the lower level.
Modifying a wash cycle in progress
If a mistake was made during the wash cycle
selection process it is possible to change the cycle,
provided that it has only just begun: press and hold
the START/RESET button for 4 seconds. After one
long beep and three short beeps, the WASH CYCLE
PHASE indicator light will switch off. Select the new
cycle and switch the machine back on by pressing
the START/RESET button.
Adding extra crockery
Press the ON/OFF button and open the door, taking
care to avoid the escaping steam, and place the
crockery inside the dishwasher. Press the ON/OFF
button again: the cycle starts from the point at which
it was interrupted.
Accidental interruptions
If the door is opened during the wash cycle, or if
there is a power cut, the cycle stops. It starts again
from the point at which it was interrupted once the
door has been shut or the electricity supply is
restored.
Loading the detergent
A successful wash also depends on the correct
amount of detergent being used, as recommended
by the manufacturer. Exceeding the recommended
amount does not result in a more effective wash and
pollutes the environment.
To obtain the best results from each washing and
drying cycle, powder detergent, rinse aid liquid and
salt should be used.
comparcompar
comparcompar
compar
tment Atment A
tment Atment A
tment A: Washing detergent
comparcompar
comparcompar
compar
tment Btment B
tment Btment B
tment B: Pre-wash detergent
1. Open cover C by
pressing button D.
2. Pour in the detergent
after consulting the
Wash
cycle table
:
• for powder detergent
use compartments A and
B
• for tablets, use
compartment A and the
bottom of the appliance,
i.e. when the cycle
requires 1 tablet, place it in compartment A and
close the cover; when it requires 2, place the second
tablet at the bottom of the appliance.
3. Remove detergent residues from the edges of the
compartment and close the cover until it clicks.
Washing options
Delayed start
It is possible to delay the start time of the cycle by
12, 9, 6 or 3 hours.
1. Press the DELAYED START button: every time the
button is pressed, a beep is emitted and the
selected delayed start indicator light illuminates.
2. Select the wash cycle and press the START/
RESET button: after the beep sounds, the timer
begins counting down.
3. Once this time has elapsed, the indicator light
switches off and the wash cycle begins.
To adjust the delay time and select a lower period of
time, press the DELAYED START button. To cancel
it, press the button repeatedly until the wash cycle
begins and the WASH CYCLE PHASE indicator light
corresponding to the start of the cycle in progress
illuminates.
4in1
When using multi-use tablets (2-in-1, 3-in-1, 4-in-1
etc.), press the 4in1 button. This option optimises
the results of the wash. The overall duration of the
programme increases by approximately 10 minutes.
This option is not recommended for use with wash
cycles which do not specify the use of multi-use
tablets (
see table of wash cycles
).
A
B
D
C
Start-up and use
* Only available in selected models.
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hotpoint-Ariston ll 69 X FR at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hotpoint-Ariston ll 69 X FR in the language / languages: English, French as an attachment in your email.

The manual is 1,4 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info