126929
18
Zoom out
Zoom in
Previous page
1/84
Next page
18
EN
Starting the dishwasher
1. Open the water inlet valve.
2. Press the ON/OFF button: the machine will emit a
beep and the ON/OFF indicator light will illuminate.
3. Open the door and measure out a suitable amount of
detergent (see below).
4. Load the racks (see Loading the racks) and shut the
door.
5. Select the wash cycle by pressing the SELECT WASH
CYCLE button: the corresponding indicator light will
illuminate.
6. Select the wash options (see below).
7. Start the cycle by pressing the START/RESET button:
the machine will emit a confirmation beep. The WASH
CYCLE PHASE indicator lights display the status of the
cycle:
Pre-wash, Wash, Rinse, or Drying.
8. At the end of the cycle two short beeps will sound and
the DRYING indicator light will flash. Switch off the
appliance by pressing the ON/OFF button and close the
water inlet valve.
9. Open the door and wait for a few minutes before
removing the crockery inside, in order to avoid burns.
Unload the racks, beginning with the lower level.
Modifying the duration of a wash cycle already in
progress
If a mistake was made during the wash cycle selection
process it is possible to change the cycle, provided that
it has only just begun:press and hold the START/RESET
button for 5 seconds After one long beep and three short
beeps, the WASH CYCLE PHASE indicator light will
switch off: select the new cycle and switch the machine
back on by pressing the START/RESET button.
Adding extra crockery
Press the ON/OFF button and open the door, taking care
to avoid the escaping steam, and place the crockery
inside the dishwasher. Press the ON/OFF button again:
the cycle starts from the point at which it was interrupted.
Accidental interruptions
If the door is opened during the wash cycle, or if there is
a power cut, the cycle stops. It starts again from the point
at which it was interrupted once the door has been shut
or the electricity supply is restored.
Loading the detergent
A successful wash also depends on the correct
amount of detergent being used, as
recommended by the manufacturer. Exceeding
the recommended amount does not result in a
more effective wash and pollutes the
environment.
Only use detergent which has been
specifically designed for dishwashers.
DO NOT USE washing up liquid.
Using excessive detergent may result in foam
residue remaining in the machine after the cycle
has ended.
To obtain the best results from each washing
and drying cycle, powder detergent, rinse aid liq-
uid and salt should be used.
compartment A: Washing detergent
compartment B: Pre-wash detergent
1. Open cover C by pressing
button D.
2. Pour in the detergent after
consulting the Wash cycle table:
 for powder detergent use
compartments A and B
 for tablets, when the cycle
requires 1 tablet, place it in
compartment A and close the
cover; when it requires 2, place
the second tablet at the bottom of the appliance.
3. Remove detergent residues from the edges of the
compartment and close the cover until it clicks.
Washing options
Delayed start
It is possible to delay the start time of the cycle by 12, 9,
6 or 3 hours.
1. Press the DELAYED START button: every time the
button is pressed, a beep is emitted and the selected
delayed start indicator light illuminates.
2. Select the wash cycle and press the START/RESET
button: after the beep sounds, the timer begins
counting down.
3. Once this time has elapsed, the indicator light
switches off and the wash cycle begins.
To adjust the delay time and select a smaller period of
time, press the DELAYED START button. To cancel it,
press the button repeatedly until the wash cycle begins
and the WASH CYCLE PHASE indicator light
corresponding to the start of the cycle in progress
illuminates.
Start-up and use
* Only available in selected models.
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hotpoint-Ariston ll 42 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hotpoint-Ariston ll 42 in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 3,52 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info