Manual Hotpoint-Ariston LI 700 DUO (page 17 of 68) (English, Dutch, French, Italian, Portuguese, Spanish)

512317

Zoom out

Zoom in

1/68

ARISTON DISHWASHER - Instructions for installation and use

ISHWASHER

First of all.

After performing all the operations

described in the previous para-

graphs, turn the water tap on com-

pletely, open the appliance door and

press ON-OFF button "A", you will

hear a short beep and the indicator

light "B" comes on. Your appliance

is now on and awaiting instructions.

Selecting the wash

cycle.

Select the wash cycle by pressing

button "P". Each time this button is

pressed, one of the indicator lights

"M" will come on in sequence, se-

lect the wash cycle you deem most

suitable for the type of dishes to

wash (take a look at page 17, where

you will find the wash cycle table).

Close the appliance door and after

a few seconds, you will hear a short

beep: the wash cycle has begun.

Modifying a wash cycle in

progress.

But if you have chosen the wrong

cycle, not to worry! You can modify

the wash cycle in progress, if it has

only just started. Open the appli-

ance door carefully to avoid any

hot water splashes, then keep but-

ton "P" pressed for approximately

5 seconds, until you hear a

prolonged beep, followed at 3

short beeps. Indicator light "M" will

come off and at this point, all the

settings will have been cancelled.

You are now free to re-set the

correct wash cycle.

You've left out a dish?

Well, it happens to everyone. Inter-

rupt the wash cycle by opening the

appliance door with the utmost

care, as usual, then insert the dish

you had forgotten. When you shut

the appliance door, the cycle will

start up from where you interrupted

it.

Finished?

The end of the wash cycle is indi-

cated by a double beep and the

flashing of the wash cycle indicator

light "M".

Turn off the water tap.

Wait a few minutes before unload-

ing the dishes: they are very hot! If

you wait a little while, they dry

better thanks to the steam. Empty

the lower rack first.

There's been a power

failure? Have you

opened the dishwasher

door?

The wash cycle stops and then

restarts when the electricity comes

back on or when you close the door.

Everything is under control!

You decide when it

starts.

When you have loaded the dishes,

you can choose when to start your

dishwasher before setting the de-

sired wash cycle. Press button "C"

to delay the start of the wash cycle

by 2, 4 or 6 hours. Each time you

press it, you will hear a short beep

and indicator light "D" correspond-

ing to the selected delay will come

on.

Now you can select the desired

wash cycle. Close the appliance

door and, after you hear the beep,

the countdown to the delayed start

will begin.

Once this time is up, the indicator

light will stop flashing and the wash

cycle will begin.

If you change your mind and you

wish to set a different delay, just

open the appliance door, press but-

ton "C" and repeat the selection.

You have loaded your dishes and you now have

to set the wash cycle. It takes just one minute

to learn how

Starting the dishwasher

Make sure the

wash cycle has

ended before

removing the

dishes!

If, on the other hand, you want to

cancel the delayed start set and

you want the wash cycle to start

immediately, press the button re-

peatedly until indicator light "D"

comes off. When you close the ap-

pliance door, the wash cycle starts

up and a short beep sounds.

You want to wash on

one rack only?

Remember to use half

the amount of

detergent.

Your dishwasher also allows you to

wash half a load, to save water and

electricity. Before setting any wash

cycle whatsoever, press button "Q"

repeatedly to select whether you

want to run a half cycle on the up-

per or lower rack. Each time you

press it, you will hear a short beep

and indicator light "R" correspond-

ing to the selected rack will come

on.

Ready, steady, go!

If opening the

door soon after

the end of the

programme,or

during it, stand

away from the

Dishwasher, to

avoid possible

injury from hot

steam.

Do you want extra

drying?

Press button "E" before you start

the selected wash cycle.

A prolonged beep will inform you

that you have selected extra drying,

a short beep indicates it has been

disabled.

With extra drying, the wash cycle

will last longer, to provide you with

drier dishes.

Warning!

Open the dishwasher door,

turn off by pressing button A,

unplug the appliance from the

electricity socket to cut off the

power supply; the power supply

cable should consequently be

easily accessible.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Hotpoint-Ariston LI 700 DUO in the language / languages: English, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 10,92 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Hotpoint-Ariston LI 700 DUO Manual

Product: