Manual Hotpoint-Ariston li 485 a c ha (page 18 of 84) (English, German, Dutch, French, Italian, Portuguese, Spanish)

127564

Zoom out

Zoom in

1/84

&

Starting the dishwasher

1. Turn the water tap on.

2. Open the door and press the ON/OFF button: the indicator

light will illuminate.

3. Measure out the detergent (see below).

4. Load the racks (see Loading the racks).

5. Select the programme by pressing the WASH CYCLE

SELECT button; the corresponding indicator light will illuminate.

6. Select the wash options* (see below).

7. Start the wash cycle by shutting the door: the machine will

emit a confirmation beep.

8. At the end of the cycle two short beeps will sound and the

WASH CYCLE indicator light will flash. Open the door, switch

off the appliance by pressing the ON/OFF button, shut off the

water tap and unplug the appliance from the electricity socket.

9. Wait for a few minutes before removing the crockery, in

order to avoid burns. Unload the racks, beginning with the

lower level.

Modifying a wash cycle in progress

If a mistake was made during the wash cycle selection

process it is possible to change the cycle, provided that it has

only just begun: open the door, taking care to avoid the

escaping steam, and press the WASH CYCLE SELECT

button, holding it for 4 seconds. After one long beep and three

short beeps, the WASH CYCLE indicator light will switch off:

select the new wash cycle and start the programme by

shutting the door.

Adding extra crockery

Open the door, taking care to avoid the escaping steam, and

place the crockery inside the dishwasher. Close the door: the

cycle starts from the point at which it was interrupted.

Accidental interruptions

If the door is opened during the wash cycle, or if there is a

power cut, the cycle stops. It starts again from the point at

which it was interrupted once the door has been shut or the

electricity supply is restored.

Loading the detergent

A good wash result also depends on the correct

amount of detergent being used; exceeding the

stated amount does not result in a more effective

wash and increases environmental pollution.

Only use detergent which has been

specifically designed for dishwashers.

DO NOT USE washing up liquid.

Using excessive detergent may result in foam

residue remaining in the machine after the cycle

has ended.

The use of tablets is only recommended for

models which offer the MULTI-FUNCTIONAL

TABLETS option.

To achieve the best results from each

washing and drying cycle, powder detergent,

rinse aid liquid and salt should be used.

compartment A: Washing detergent

compartment B: Pre-wash detergent

1. Open cover C by pressing button

2. Pour in the detergent after

consulting the Wash cycle table:

 for powder detergent use

compartments A and B

 for tablets, when the cycle requires

1 tablet, place it in compartment A and

close the cover; when it requires 2, place the second tablet at

the bottom of the appliance.

3. Remove detergent residues from the edges of the

compartment and close the cover until it clicks.

Washing options

Delayed start

It is possible to delay the start time of the cycle by 2, 4 or 6

hours.

1. Press the DELAYED START button: every time the button is

pressed, a beep is emitted and the selected delayed start

indicator light illuminates.

2. Select the wash cycle and shut the door: after the beep

sounds, the timer begins counting down.

3. Once this time has elapsed, the indicator light switches off

and the wash cycle begins.

To adjust the delay time and select a smaller period of time,

press the DELAYED START button. To cancel it, press the

button repeatedly until the selected delayed start indicator

light switches off. The wash cycle will start automatically as

soon as the door is shut.

Start-up and use

* Only available in selected models.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Hotpoint-Ariston li 485 a c ha in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 3,47 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Hotpoint-Ariston li 485 a c ha Manual

Product: