Manual Hotpoint-Ariston lft 116 a ha (page 18 of 84) (English, German, Dutch, French, Italian, Portuguese, Spanish)

127210

Zoom out

Zoom in

1/84

Start-up and use

Measuring out the detergent

A good wash result also depends on the correct

amount of detergent being used; exceeding the

stated amount does not result in a more effective

wash and increases environmental pollution.

Only use detergent which has been

specifically designed for dishwashers.

DO NOT USE washing up liquid.

Using excessive detergent may result in foam

residue remaining in the machine after the cycle

has ended.

The use of tablets is only recommended for

models which offer the MULTI-FUNCTIONAL

TABLETS option.

To achieve the best results from each washing

and drying cycle, powder detergent, rinse aid

liquid and salt should be used.

Compartment A: Washing detergent

Compartment B: Pre-wash detergent

1. Open cover C by pressing button

2. Pour in the detergent after

consulting the Table of wash

cycles:

 For powder detergent use

compartments A and B.

 For detergent in tablet form: when

the cycle requires 1 tablet, place it in compartment A

and close the cover; when it requires 2, place the

second tablet at the bottom of the appliance.

3. Remove detergent residues from the edges of the

compartment and close the cover until it clicks.

* Only available in selected models.

Starting the dishwasher

1. Turn the water tap on.

2. Open the door and press the ON/OFF button: you will

hear a short beep and the ON/OFF and wash cycle

indicator lights switch on for a few seconds.

3. Measure out the detergent (see below).

4. Load the racks (see chapter entitled Loading the

racks).

5. Select the wash cycle in accordance with the type of

crockery and its soil level (see Table of wash cycles), by

pressing the P button; the indicator light corresponding

to the selected wash cycle will switch on.

7. Start the wash cycle by shutting the door: after a few

seconds have passed, a long beep signals the start of

the wash cycle.

8. Two short beeps and one long one indicate the end of

the wash cycle and the indicator light corresponding to

the wash cycle flashes slowly. Open the door, switch off

the appliance by pressing the ON/OFF button, shut off

the water tap and unplug the appliance from the

electricity socket.

9. Wait for a few minutes before removing the crockery,

in order to avoid burns. Unload the racks, beginning with

the lower level.

The order in which the different wash programmes are

displayed will change according to the frequency with

which each cycle is used.

Modifying a wash cycle in progress

If a mistake was made during the wash cycle selection

process it is possible to change the cycle, provided that it

has only just begun: open the door, taking care to avoid the

escaping steam, and press and hold the ON/OFF button;

the machine will switch off with a long beep. Switch the

machine back on using the ON/OFF button and select the

new wash cycle using the P button; start the cycle by

closing the door.

Adding extra crockery

Without switching off the machine, open the door, taking

care to avoid the escaping steam, and place the

crockery inside the dishwasher. Close the door: the

cycle starts from the point at which it was interrupted.

Accidental interruptions

If the door is opened during the wash cycle, or if there is

a power cut, the cycle stops. It starts again from the point

at which it was interrupted once the door has been shut

or the electricity supply is restored.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Hotpoint-Ariston lft 116 a ha in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 3,81 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Hotpoint-Ariston lft 116 a ha Manual

Product: