Manual Hotpoint-Ariston FTCF 87B (page 13 of 52) (English, Dutch, French)

591501

Zoom out

Zoom in

1/52

Start and Programmes

●

Programmes knob

! Warning, if after pressing the START/PAUSE button

the programme knob position has changed, the new

position will NOT change the programme selected.

To change a selected programme, press the

START/PAUSE button , the light flashes Amber to

indicate the programme is paused. Select the new

programme and any options required, the light will then

flash green. Press the START/PAUSE button again

and the new programme will start.

●

OPTION buttons / lights

These buttons are used to customise the selected

programme to your requirements. A programme must

have been selected on the programme knob before an

option can be selected. Not all options are available for all

programmes (see Start and Programmes). If an option is

not available and you press the button, the buzzer will

beep three times. If the option is available the option light

in the button lights to confirm the selection.

Progress ( Drying, Cool Tumble) icons

These are part of the Display, they indicate the progress

of the dryer. Each icon comes on as the corresponding

phase starts.

Time Delay (Delay Timer)

The start of some programmes (see Start and

Programmes) can be delayed for up to 24 hours. Ensure

the water container is emptied before setting a delayed

start. During this period the clothes are occasionally

tumbled to help prevent creases developing.

Ready to Iron

This option allows you to dry loads where only some

of the items need ironing and you do not wish to fully

dry those items.

When Iron Dry level is reached, a buzzer sounds to let

you know that the items that need ironing can be

removed. The dryer then stops and the Start/Pause

light flashes orange. Remove the items you wish to

iron, close the door and press the Start/Pause button,

the dryer continues until the remaining items reach the

selected dryness level.

It can be used on load sizes up to 3kg.

Note: This option is not available with the ‘Iron Dry’ and

‘Damp Dry’ dryness levels.

Less Tangled

This option has the drum movement modified to give a

tumbling action that reduces tangling and knotting of your

clothes.

The Less Tangled option gives best results when used

with smaller loads.

Heat Level buttons and lights

Not all programmes allow you to change the heat level

and some programmes allow all three heat level options:

Low, Medium and High.

When the heat level options are available pressing this

button changes the heat level and the light corresponding

to the selection is lit.

The Controls

8:88

●

DISPLAY

The display shows either the amount of time delay

remaining or an indication of the amount of time left for a

drying programme (see The Display).

The colons between the hours and minutes in the display

flash to show that the time is counting down.

When the programme finishes its cool tumble phase the

display will show ‘End’.

●

Empty Water Icon / Container

(If you have plumbed your dryer to a drain this icon can

be ignored, as there is no need to empty the water

container).

When this icon is on ( ) it reminds you to empty the

water container.

If the water container fills during a programme, the

heater turns off and the dryer does a period of Cool

Tumble then the buzzer sounds, the ‘water container

full’ icon flashes, the display shows and the

‘empty water’ icon is on.

You must empty the water container and restart the

dryer or the clothes will not dry. After re-starting the

dryer the display will take a few seconds to refresh.

To avoid this always empty the water container each

time you use the dryer (see Maintenance).

●

Door Opening

Opening the door (or pressing the Start/Pause button)

during a programme will stop the dryer and have the

following effects:

●

The START/PAUSE light flashes Amber.

●

During a delay phase the delay will continue to

count down. The START/PAUSE button must be

pressed to resume the delay programme.

●

The START/PAUSE button must be pressed to

resume programme. The progress lights will change

to show the current status and the Start/Pause light

will stop flashing and turn green.

●

Changing the programmes knob will select a new

programme and the START/PAUSE light will flash

green. You can use this to select the Refresh

programme to cool the clothes, if you find them

dry enough. Press the START/PAUSE button to

begin a new programme.

●

Note

If you have a power cut, switch off the power or remove

the plug. When power is restored, press and hold the

ON/OFF button until the dryer reactivates, then press the

Start/Pause button.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Hotpoint-Ariston FTCF 87B in the language / languages: English, Dutch, French as an attachment in your email.

The manual is 1,66 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Hotpoint-Ariston FTCF 87B Manual

Product: