Manual Hotpoint-Ariston ald 140 (page 39 of 60) (English, German, Dutch, French)

306902

Zoom out

Zoom in

1/60

Margherita - Iinstructions for installation and use

ARGHERITA

Before calling, read the following

Troubleshooting

In most cases, when your washing machine fails to work, the problems

arising can be easily solved without having to call for a technician. Before

calling for assistance, always check these points.

The washing machine

fails to start.

Is the plug correctly

inserted into the socket? It

could have been moved whilst

cleaning.

Is there electricity in the

house?

A circuit breaker may have

switched off as a result of too

many electrical appliances

working at the same time. Or

maybe due to a general failure

in your entire area.

Is the washing machine door

closed properly?

For safety reasons, the

washing machine cannot work

if the door is open or not shut

properly.

Is the On/Off button

pressed?

If it is, then a programmed

start has been set.

Is the Start/Reset button

pressed?

If it is, then a programmed

start has been set.

Is the water supply turned

on? For safety reasons, if the

washing machine does not

load water, it cannot start a

wash cycle.

RIGHT

WRONG

Turn off the water

supply after use.

This will eliminate

the possibility of

leakage.

Always leave the

appliance door

ajar to avoid bad

odours.

Clean the

appliances

exteriors gently.

To clean the

exteriors and the

rubber parts of

the appliance,

always use a soft

cloth dipped in

warm and soapy

water.

Leave the washing

machine plugged in

while cleaning.

Even during mainte-

nance, the appliance

should always be

unplugged.

Use solvents and

aggressive abrasives.

Never use solvents or

abrasives to clean the

external and rubber

parts of the washing

machine.

Neglect the detergent

dispenser.

It is removable and

can easily be cleaned

by leaving it under

running water.

Go on holiday without

thinking about her.

Before leaving, always

make sure that the

washing machine is

unplugged and that

the water supply is

turned off.

The washing machine

fails to fill with water.

Is the hose correctly

connected to the tap?

Is there a water shortage ?

There could be work in

progress in your building or

street.

Is there sufficient water

pressure? The autoclave may

be malfunctioning.

Is the tap filter clean? If the

water is very calcareous, or if

work has recently been carried

out on the water piping, the tap

filter could be clogged with

particles and debris.

Is the rubber hose kinked?

The tract of the rubber hose

bringing water to washing

machine must be as straight as

possible. Make sure it is not

squashed or kinked.

The washing machine

continuously fills and

drains water.

Is the drain hose

positioned too low? It must

be installed at a height ranging

from 60 to 100 cm.

Is the end of the hose

immersed in water?

Does the wall drainage

system have a breather

pipe? If the problem persists

even after these checks, turn

the water supply off the

machine and call for

assistance.

If you live on an upper floor of

your building, there may be a

problem with your drain trap.

To solve this problem, a special

valve must be installed.

Simple: with the new Ariston technology, you need less than

half of it, to get good results on twice as much!

This is why you cannot see the water through the door:

because there is little, very little of it, to respect the

environment yet without renouncing maximum cleanliness.

And, on top of that, you are also saving electricity.

But where did all the water go?

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Hotpoint-Ariston ald 140 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 3,46 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Hotpoint-Ariston ald 140 Manual

Product: