Manual Hotpoint-Ariston al 108 x (page 48 of 60) (English, German, Dutch, French)

306891

Zoom out

Zoom in

1/60

M O

Stain removal (see page 49)

Thanks to this command, Mar-

gherita 2000 will carry out a more

intensive wash that optimises the

effectiveness of the liquid

additives, thus allowing more

resistant stains to be removed.

When you press the stain removal

button, you cannot activate the

pre-wash.

On-off

When button L is pressed, the

washing machine is switched on,

when it is not the machine is

switched off.

Turning the appliance off does

not cancel the selected

programme.

The on-off lamp

Lamp M flashes when the

appliance is switched on and

awaiting a programme to be set.

A steady light means the

appliance has accepted the

selected programme.

The door block lamp

The safety lamp indicates that the

washing machine door is locked

to prevent it from being opened

accidentally. To avoid any

damages to lock mechanism, you

must wait for the lamp to

extinguish, before attempting to

open the door which takes

around three minutes.

Programme key

This contains the descriptions of

the wash programmes and the

various functions connected to

the buttons. Pull it outwards to

open it.

Anti-crease

This button allows you to

interrupt a programme (on

symbol

) keeping the washing

soaking in water before the spin

cycle. It is a very useful button

in particular because it can be

used for delicates and synthetics.

It is only to be used with wash

program-mes for synthetic

fabrics, silk and curtains when it

is impossible for you to take the

washing out immediately. Before

opening the washing machine

door, finish the wash cycle as

follows:

Silk and curtains: press button

F and Margherita 2000 will drain

the water.

Synthetic fabrics: press button F

if you want a spin cycle, or turn

knob A to symbol

if you

want the water to be drained.

Extra economy

Reduces water consumption

during the rinse cycles. We

recommend that you use this

function only with small laundry

loads, dosing the detergent

proportionally.

Rapid wash

This button reduces the length of

the wash programme by about

30%. It cannot be used with

special programmes (see page 46)

or those for wool and silk.

Here Im in command

Understanding the control panel

Making the right choice is important. And its easy.

Margherita 2000s knobs are hidden.

Just press them lightly in the middle

to extract them.

Programme selector knob

and programmed start

It is used to select the wash

programme.

Before setting anything, press

the on/off button (L). Lamp M

will begin to flash.

The chosen programme is visible

through the window O.

Remember that the knob can

only be turned in a clockwise

direction.

To select the programmes, make

sure the mark situated on

window O is aligned with the

symbol/number corresponding to

the desired programme for at

least 5 seconds. After these 5

seconds, the setting is accepted,

lamp M stops flashing (staying

lit) and the wash cycle begins. If

you want to interrupt the

programme in progress or to set

a new one, select one of the

symbols

(Stop/Reset) and wait

for 5 seconds: when the

cancellation has been accepted,

lamp M will flash.

You can use this knob to delay

the washing machines operation:

select one of the four positions

for programmed start and wait for

5 seconds. This is when the

setting has been accepted (lamp

M stops flashing and stays lit)

and you can select the

programme you require.

Pilot lamp M has a particular

flashing action (2 seconds lit and

4 seconds off) to indicate that the

delayed start has been set.

During this phase, it is possible

to open the door and modify the

washing load.

After the wash cycle has been set

and accepted by the washing

machine, turning the knob will

have no effect (except for when

it is on position Stop/Reset).

Temperature control knob

It is used to set the wash tempe-

rature in the recommended

programme table on pag. 46. It

also allows you to reduce the tem-

perature recommended for the

selected programme, and even to

set a cold wash cycle (

Spin exclusion knob

It is used to exclude the spin

cycle (by choosing symbol

) or

to reduce the spin speed of the

selected programme. The

maximum speed for the four

types of fabric are:

Fabric Speed

Cotton 1000 rpm

Synthetics 800 rpm

Wool 600 rpm

Silk no

Note: distribution phase will be

carried out at low speed.

Detergent dispenser

It is divided into three

compartments:

1. Detergent for pre-wash;

2. Detergent for the main cycle

wash;

3. Fabric conditioner.

The washing machine is

equipped with an extra

compartment 4 (provided as an

accessory) for the bleach, to be

inserted in compartment 1.

The detergent dispenser with

the additional bleach

compartment is here.

Margherita 2000 - Instructions for installation and use

ARGHERITA

2000

MAX

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Hotpoint-Ariston al 108 x in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 4,93 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Hotpoint-Ariston al 108 x Manual

Product: