642765
6
Zoom out
Zoom in
Previous page
1/11
Next page
10 11
CENTERING THE RUNNING BELT
The running belt has been properly adjusted at the factory before it was shipped. At
times the belt can move off-center during shipment. Before operating the treadmill,
make sure the belt is centered and remains centered to maintain smooth operation.
If the running belt is too far to the right side: With the treadmill running at
1 mph, turn the left adjustment bolt counter-clockwise ¼ turn at a time (using the
supplied Allen wrench). Check the belt alignment. Allow belt to run a full cycle to
gauge if more adjustment is needed. Repeat if necessary, until the belt remains
centered during use.
If the running belt is too far to the left side: With the treadmill running at 1 mph
or 1.6 kmh, turn the right adjustment bolt counter-clockwise ¼ turn at a time (using
the supplied Allen wrench). Check the belt alignment. Allow belt to run a full cycle
to gauge if more adjustment is needed. Repeat if necessary, until the belt remains
centered during use.
*NOTE: Folding, moving and leveling information might vary according to the model
you buy. Please see Owner’s manual for further information.
For centering the belt: For centering the belt you may refer to the marking dot on
motor cover to line-up the edge of the logo on belt.
Do not run belt faster than 1 mph or 1.6 kmh while centering. Keep fingers,
hair and clothing away from belt at all times.
CAUTION
BELT IS TOO FAR TO THE RIGHT SIDE
BELT IS TOO FAR TO THE LEFT SIDE
TENSIONING THE RUNNING BELT
The running belt has been properly adjusted at the factory before it was shipped. At
times the belt can move off-center during shipment.
Running belt should NOT be moving during tensioning. Over-tightening
the running belt can cause excessive wear on the treadmill as well as its
components. Never over-tighten the belt.
CAUTION
If you can feel a slipping sensation when running on the treadmill, the running belt
must be tightened. In most cases, the belt has stretched from use, causing the belt
to slip. This is a normal and common adjustment. To eliminate this slipping, turn
the treadmill off and tension both the rear roller bolts using the supplied Allen
wrench, turning them ¼ turn to the right as shown. Turn the treadmill on and check for
slipping. Repeat if necessary, but never turn the roller bolts more than ¼ turn at a
time. Belt is properly tensioned when the slipping sensation is gone.
TIGHTENS RIGHT SIDE OF ROLLER
TIGHTENS LEFT SIDE OF ROLLER
LEVELING THE TREADMILL
Your treadmill should be leveled for optimum use. Once you have placed your treadmill
where you intend to use it, raise or lower one or both of the adjustable levelers
located on the bottom of the treadmill frame*. A carpenter’s level is recommended.
If your treadmill is not level, the running belt may not track properly. Once you have
leveled your treadmill, lock the levelers in place by tightening the nuts against the
frame (Some treadmills do not have levelers).
LOCK
ADJUSTMENT
ADJUST
HEIGHT
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Horizon Fitness ELITE T-PRO at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Horizon Fitness ELITE T-PRO in the language / languages: English as an attachment in your email.

The manual is 0,79 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Horizon Fitness ELITE T-PRO

Horizon Fitness ELITE T-PRO User Manual - English - 36 pages

Horizon Fitness ELITE T-PRO Installation Guide - German - 20 pages

Horizon Fitness ELITE T-PRO User Manual - German - 36 pages

Horizon Fitness ELITE T-PRO Installation Guide - Dutch - 20 pages

Horizon Fitness ELITE T-PRO User Manual - Dutch - 36 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info