594433

Hoover Turbo Scrub Carpet Cleaner Manual

22
Zoom out
Zoom in
Previous page
1/60
Next page
11
Actual model may vary from images shown.
IMPORTANT
To avoid saturating carpet, do not use more
than 4 wet strokes over one area. Always end
with dry strokes.
Step 2
8. Release trigger and slowly push cleaner
forward over area just sprayed with solution
(dry stroke). Then slowly pull cleaner back
toward you without squeezing trigger (dry
stroke). Continue using dry strokes until little
water is visible passing through the Dirty Water
Tank lid (Pass over the same area a minimum
of 4 times = 2 while squeezing the trigger and
2 without).
NOTE: For best results, use straight, parallel
strokes. Overlap strokes by 1 inch to help prevent
streaking.
9. Keep nozzle flat on floor for both forward and
reverse strokes.
For best cleaning results and to aid in faster
drying of carpet, end with more dry strokes.
(Continue using dry strokes until little water is
visible passing through the Dirty Water Tank lid.)
Empty Dirty Water Tank when the motor sound
becomes higher pitched and there is a loss in
suction (see “Automatic shut-off”).
When finished cleaning, follow “After Cleaning”
instructions on page 12.
AFTER USE
Allow carpet or upholstery to dry. To help prevent
matting and resoiling the carpet, keep children and
pets away from surface until it is completely dry. If it
is necessary to walk on damp carpet, place towels
or white cloths on the traffic areas.
If furniture must be replaced before the carpet is dry,
place plastic or aluminum foil under legs of furniture
so metal slides or wood finishes will not stain the
carpet.
1. See “Dirty Water Tank: How to Empty” page 9.
2. See “Dirty Water Tank: How to Clean” page 9.
NOTE: Let Dirty Water Tank and Dirty Water Tank
Lid air dry before Carpet Washer is stored.
3. See “Cleaning Nozzle” page 16.
4. See “Cleaning Brushes” page 16.
5. Remove lint from filter screen located behind
nozzle.
IMPORTANT
When brushes seem to be rotating slowly,
disconnect cleaner from electical outlet and
check and clean the screen behind the nozzle
(see arrow below).
10. For best cleaning results, Hoover recommends
to rinse the carpet with water only. This will
remove residual carpet cleaning solution from
your carpets. To Rinse with water only, fill
solution tank with hot tap water only and
repeat cleaning strokes.
11. For heavily soiled areas, repeat cleaning
process. Avoid saturating carpet.
NOTE: It is best to alternate wet and dry strokes
as described above.
Water will drip from the brushes and underside
of the product after use and may puddle. To
avoid damage to wood and laminate flooring
and to avoid potential slip hazard, after use (a)
do not leave the product on wood and laminate
surfaces and remove to a hard surface and (b)
place unit on absorbent material (such as a
towel) to soak up drips.
CAUTION
! !
… 22 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hoover Turbo Scrub Carpet Cleaner at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hoover Turbo Scrub Carpet Cleaner in the language / languages: English, French, Spanish as an attachment in your email.

The manual is 2,13 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info