594437

Hoover SteamVac CleanSurge Manual

14
Zoom out
Zoom in
Previous page
1/40
Next page
5. T
ur
n carpet cleaner on. If neces
-
sar
y
, r
efer to “Before using tool”
section to remove air from system.
6. Gently press the tool onto the fab-
ric. Press the trigger and slowly pull
the nozzle over the fabric.
7. Overlap strokes by 1/2 inch to
help prevent streaking.
Make additional str
okes without
pressing the trigger to remove more
moistur
e.
8. T
o clean in cor
ners or cr
eases, lift
the tool one-half inch from the fabric
and press the solution trigger.
9. Vacuum up the solution with the
tool without pr
essing the trigger
.
3-19
3-20
Read “Before you begin cleaning”
instructions on page 10.
1. Place handle in upright position.
Agitator brushes will not rotate
while handle is in upright position.
2. Fill clean solution tank with
HOOVER Carpet/Upholstery
Detergent according to instructions
on pages 8 and 9.
3. Attach tool to end of hose.
4. Hose length may require that
machine be placed at the top of the
stairs to clean upper half of stairway
and at bottom of stairs to clean
lower half.
To prevent machine from falling,
use extra caution when cleaning
on stairs.
Do not place carpet cleaner on
stairs.
Do not point tools toward people
or pets.
5. Dry hands and plug carpet clean-
er into a
properly grounded outlet.
6. Turn carpet cleaner ON. If neces-
sary, refer to “Before using tool” sec-
tion to remove air from system.
7. Pre-spray the carpeted stair by
holding the tool about one inch
above the carpet and push it for
-
ward while pressing the trigger
(equals one wet str
oke).
Cleaning upholstery
8. Position tool against the riser and
slightly press it into carpet pile. Press
the trigger and pull the tool slowly over
the carpet (second wet stroke). Release
trigger at end of stroke.
9. Lift tool, and position it against
riser. Pull tool slowly over carpet
without pressing trigger (dry stroke).
It is best to alternate wet and dry
strokes as described above. End
with more dry strokes to aid in faster
drying of carpet.
10. Overlap strokes by 1/2 inch to
help prevent streaking.
To avoid saturating carpet, do not
use more than 4 wet strokes over
any one area.
Always end with dry
strokes.
If additional cleaning is necessary,
wait until the carpet is completely
dry before using the tool again.
11. Empty recovery tank when the
motor sound becomes higher
pitched and there is a loss in suc-
tion (see “Automatic shut-of
f”, page
8).
When finished cleaning, follow “After
cleaning” instructions on pages 10
and 11 and “After using tool” instruc
-
tions on pages 13 and 14.
Read “Before you begin cleaning”
Instructions on page 10.
Be sure to check the cleaning code
on your upholstery.
Use your
HOOVER SteamVac™ carpet
cleaner only on upholstery
marked “W” or “W/S”.
1. Place handle in upright position.
Agitator brushes will not rotate
while handle Is In upright position.
2. Fill clean solution tank with
HOOVER Carpet/Upholstery
Detergent according to instructions
on pages 8 and 9.
3. Attach tool to end of hose.
Do not point tools toward people
or pets.
4. Dry hands and plug carpet clean-
er into a properly grounded outlet.
Cleaning carpeted
stairs
3-18
Snap clip back into position making
sure solution hose (N) is not
pinched and moves freely.
14
3
-16
N
F
3-17
Replace recovery tank front panel
(F).
Slide panel down until it
snaps firmly in place.
… 14 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hoover SteamVac CleanSurge at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hoover SteamVac CleanSurge in the language / languages: English, French, Spanish as an attachment in your email.

The manual is 2,63 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info