594432

Hoover Power Scrub Carpet Cleaner Manual

14
Zoom out
Zoom in
Previous page
1/30
Next page
14
14
Actual model may vary from images shown.
CLEANING UPHOLSTERY
Read “Before You Begin Cleaning” instructions.
Be sure to check Hoover Cleaning Guide on page
10 and the cleaning code on your upholstery. Use
your cleaner only on upholstery marked “W” or
“W/S”.
1. Attach hose and solution tube as instructed.
2. Place handle in upright position. SpinScrub
brushes will not rotate while handle is in upright
position.
3. Fill Clean Water Tank according to instructions
on (Pg. 8).
4. Fill solution container with HOOVER
®
solution according to instructions on (Pg. 8).
Do not use hard floor cleaning solution when
cleaning upholstery.
5. Attach tool to end of hose.
6. Dry hands and plug cleaner into a properly
grounded outlet.
39
7. Set Wash/Rinse Selector to WASH. Turn
cleaner ON.
8. Gently press the tool onto the fabric. Press the
trigger and slowly pull the nozzle over the
fabric (Fig. 39).
9. Overlap strokes by 1/2 inch to help prevent
streaking.
10. Make additional strokes without pressing the
trigger to remove more solution.
To clean in corners or creases, lift the tool one
half inch from the fabric and press the solution
trigger.
11. For heavily soiled areas, it may be necessary
to repeat the cleaning process. Make
crisscrossing strokes to the original pattern;
overlap each pass (Fig. 40).
Make no more than 2 passes with the solution
over any one area to prevent over-wetting and
damage to fabric.
12. If you would like to rinse the carpet with water
only, set Wash/Rinse Setting switch to RINSE
(Fig. 41). For best cleaning results, Hoover
recommends to rinse the carpet with water
only. This will remove residual carpet cleaning
solution from your carpets. Then set Wash/
Rinse Selector to rinse and repeat steps 7 and 8.
If additional cleaning is necessary, wait until the
upholstery is completely dry before using the tool
again.
Empty Dirty Water Tank when the motor sound
becomes higher pitched and there is a loss in
suction (see “Automatic Shut-Off”).
When finished cleaning, follow “After Cleaning”
and “After Using Tool” instructions.
40
NETTOYAGE DE MEUBLES
Lire les instructions de la section « Avant de
commencer le nettoyage » à la page 10.
S’assurer de vérifier le code de nettoyage figurant
sur le tissu qui recouvre vos meubles. N’utiliser
l’aspirateur qu’avec des tissus portant le code « W
» ou « W/S ».
1. Fixer le tuyau et le tube de solution comme
l’indiquent les figures.
2. Mettre le manche en position verticale. Le
rouleau brosse agitateur ne tournera pas tant
que le manche sera en position verticale.
3. Remplir le réservoir d’eau en suivant les
instructions des figures (Pg. 8).
4. Remplir le contenant de détergent avec la
solution nettoyante de HOOVER
MD
,
conformément aux instructions illustrées sur la
figure (Pg. 8). Ne pas utiliser la solution
nettoyante pour planchers durs pour nettoyer
des meubles.
5. Fixer l’accessoire à l’extrémité du tuyau.
6. Essuyer vos mains et brancher le cordon dans
une prise électrique adéquatement mise à la
terre.
7. Mettre le commutateur du mode de rinçage en
mode WASH (lavage). Mettre l’appareil en marche.
8. Appuyer doucement sur le tissu avec l’accessoire.
Appuyer sur la gâchette et passer lentement la
buse sur le tissu (Fig. 39).
9. Chevaucher les passages de � po (1,3 cm) afin
d’éviter les marques.
10. Effectuer des passages supplémentaires sans
appuyer sur la gâchette pour enlever davantage
d’humidité.
Pour nettoyer dans les coins ou les plis, soulever
l’accessoire à � po (1,3 cm) du tissu et appuyer
sur la gâchette pour l’application de solution.
Aspirer la solution avec l’accessoire sans
appuyer sur la gâchette.
11. Pour les surfaces très sales, il peut être
nécessaire de répéter le processus de
nettoyage. Faire des tracés en croix par rapport
aux passages initiaux, et chevaucher chaque
passage.
39
Ne pas faire plus de deux passages humides à
un même endroit afin d’éviter que la surface ne
soit trop mouillée, ce qui pourrait endommager
le tissu.
12. Pour optimiser les résultats de nettoyage,
Hoover recommande de rincer la moquette
avec de l’eau seulement. Cela éliminera les
résidus de nettoyant de vos moquettes. Régler
ensuite le commutateur nettoyage/rinçage à la
position RINSE, (Fig. 41) et répéter les étapes
7 et 8.
Une fois le nettoyage terminé, suivre les
instructions de la section « Après le nettoyage »
à la page ainsi que les instructions de la section
« Après l’utilisation d’un accessoire ».
40
41
41
… 14 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hoover Power Scrub Carpet Cleaner at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hoover Power Scrub Carpet Cleaner in the language / languages: English, French, Spanish as an attachment in your email.

The manual is 2,22 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info