594429
13
Zoom out
Zoom in
Previous page
1/60
Next page
13
Actual model may vary from images shown.
Read “Before You Begin Cleaning” instructions on
page 9.
Place handle in upright position. Agitator brushes
will not rotate while handle is in upright position.
Fill clean water tank according to instructions for
Fig. 2.9.
Fill detergent container with HOOVER
®
detergent
according to instructions for Fig. 2.10.
Attach tool to end of hose.
Do not point tools toward people or pets.
CLEANING CARPETED STAIRS
A
B
4.4
4.5
WARNING
! !
Use extra care when cleaning on stairs. To avoid
personal injury or damage, and to prevent the
cleaner from falling, always place cleaner at
bottom of stairs or on floor. Do not place cleaner
on stairs or furniture, as it may result in injury or
damage.
Dry hands and plug cleaner into a properly grounded
outlet.
Set Wash/Rinse Setting switch to WASH. Turn
cleaner ON.
Prime the pump by lowering the hose down to the
floor and hold the trigger for up to 1 min.
4.4 Pre-spray the carpeted stair by holding the tool
(A) or (B) about one inch above the carpet and push
it forward while pressing the trigger (equals one wet
stroke).
Position tool against the riser and slightly press it
into carpet pile. Press the trigger and pull the tool
slowly over the carpet (second wet stroke). Release
trigger at end of stroke.
4.5 Lift tool, and position it against riser. Pull tool
slowly over carpet without pressing trigger (dry
stroke).
Overlap strokes by 1/2 inch to help prevent
streaking.
It is best to alternate wet and dry strokes as
described above. End with more dry strokes to aid
in faster drying of carpet.
To avoid saturating carpet, do not use more than
4 wet strokes over any one area. Always end with
dry strokes.
If additional cleaning is necessary, wait until the
carpet is completely dry before using the tool
again.
Empty Dirty Water Tank when the motor sound
becomes higher pitched and there is a loss in suction
(see “Automatic Shut-Off”, Fig. 2.19).
When finished cleaning, empty Clean Water Tank,
wash and rinse dirty Water Tank and let air dry. See
“After Cleaning” section (Page. 12) for additional
information.
G
H
HOW TO ATTACH TOOLS
Place handle in upright position and remove hose
from rack.
Turn off and unplug cleaner from electrical outlet.
All tools attach to the hose in the same manner:
4.3 Connect tool to hose by sliding it onto connector
until the tab (G) locks it securely.
4.3
CAUTION
! !
To reduce the risk of injury from moving parts,
unplug cleaner before connecting SpinScrub
®
Hand Tool.
Not to be used for grooming a pet.
Using your thumb, push forward and up on the latch
(H) to remove tool.
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hoover MaxExtract Deep Cleaner at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hoover MaxExtract Deep Cleaner in the language / languages: English, French, Spanish as an attachment in your email.

The manual is 2,69 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info