594429

Hoover MaxExtract Deep Cleaner Manual

10
Zoom out
Zoom in
Previous page
1/60
Next page
10
Actual model may vary from images shown.
R
I
N
S
E
W
A
S
H
3.1/3.1a
CLEANING CARPET
Read “Before You Begin Cleaning” instructions.
Fill Clean Water Tank according to instructions
for Fig. 2.9.
Fill detergent container with Hoover
®
detergent
according to instructions for Fig. 2.10.
Select proper SpinScrub
®
mode (Fig. 2.6).
Dry hands and plug cord into a properly
grounded outlet.
IMPORTANT
To assure proper rinsing, it is important to keep
the cleaner on the same path backward as
forward.
3.2
IMPORTANT
To avoid saturating carpet, do not use more
than 4 wet strokes over one area. Always end
with dry strokes.
Release trigger and slowly push cleaner forward
over area just sprayed with solution (dry stroke).
Then slowly pull cleaner back toward you without
squeezing trigger (dry stroke). Continue using dry
strokes until little water is visible passing through
FOR MODELS WITH AUTO RINSE FEATURE
(available on select models only)
3.1a Set Wash/Rinse Setting switch to Wash/
Auto Rinse. Turn cleaner ON.
3.2a Squeeze trigger to apply cleaning
solution and slowly push cleaner forward
(equals one wet stroke). The cleaner washes
on the forward stroke.
Continue to squeeze trigger and slowly pull
cleaner back toward you (second wet stroke).
The cleaner rinses the carpet on the
backward pass.
R
I
N
S
E
W
A
S
H
3.3
3.2a
AUTO
RINSE WASH
FOR MODELS WITHOUT AUTO RINSE
FEATURE
3.1 Set Wash/Rinse Setting switch to Wash.
Turn cleaner ON.
3.2 Squeeze trigger to apply cleaning solution
and slowly push cleaner forward (equals one
wet stroke).
Continue to squeeze trigger and slowly pull
cleaner back toward you (second wet stroke).
Step 1
the Dirty Water Tank lid (Pass over the same area a
minimum of 4 times = 2 while squeezing the trigger
and 2 without).
For best results, use straight, parallel strokes.
Overlap strokes by 1 inch to help prevent
streaking.
Keep nozzle flat on floor for both forward and
reverse strokes.
3.3 If you would like to rinse the carpet with water
only, set Wash/Rinse Setting switch to RINSE.
Repeat cleaning motion. In this setting, rinsing will
be done on both forward and reverse strokes.
For heavily soiled areas, repeat cleaning motion.
Avoid saturating carpet.
It is best to alternate wet and dry strokes as
described above.
For best cleaning results and to aid in faster drying
of carpet, end with more dry strokes. (Continue
using dry strokes until little water is visible passing
through the Dirty Water Tank lid.)
Empty Dirty Water Tank when the motor sound
becomes higher pitched and there is a loss in
suction (see “Automatic shut-off”, Fig. 2.19).
When finished cleaning, follow “After Cleaning”
instructions on page 12.
Step 2
IMPORTANT
Do not clean over floor electrical outlets.
To avoid walking on damp carpet, start at the end of
the room farthest from the door or path to sink
where tanks will be emptied and filled.
Step on handle release pedal and lower handle to
operating position.
Pull Trigger = WET
Release Trigger = DRY
… 10 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hoover MaxExtract Deep Cleaner at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hoover MaxExtract Deep Cleaner in the language / languages: English, French, Spanish as an attachment in your email.

The manual is 2,69 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info