705496

Hoover HTDBWH7A1TCE-80 Manual

11
Zoom out
Zoom in
Previous page
1/24
Next page
4. MAINTENANCE AND
CLEANING
To clean the washing machine exterior, use
a damp cloth, avoiding abrasives, alcohol
and/or solvents. To maintain a good wash
performance we recommend that the soap
drawer and pump filters are regularly
cleaned. A monthly service wash, using a
proprietary cleaner is also recommended.
We recommend you clean the drawer to
avoid accumulating detergent and
additive residue.
To do this, extract the drawer using slight
force, clean it with running water and
reinsert it in its housing.
Ensure the siphon cap is correctly
refitted.
The washing machine comes with a
special filter able to trap large residue,
such as buttons or coins, which could
clog the drain.
ONLY AVAILABLE ON CERTAIN MODELS:
pull out the corrugated hose, remove the
stopper and drain the water into a
container.
Ensure all the water has been emptied
from the drum.
Before unscrewing the filter, we
recommend you place an absorbent cloth
under it to keep the floor dry. A small
amount of water will come out of the filter
as you remove it - this is normal.
Turn the filter counter-clockwise to the
limit stop.
Remove and clean the filter; when
finished, replace it turning it clockwise.
The filter handle will be locked when it is
not possible to turn any further and the
handle is horizontal. Smearing a small
amount of liquid soap on the filter seal will
help refitting.
Repeat the previous steps in reverse
order to reassemble all parts.
Should the washing machine be stored in
an unheated room for a long period of
time, drain all water from tubes.
Unplug the washing machine.
Detach the tube from the drainage
system and clip on the rear of the
machine and lower it, fully draining water
into a bowl.
Secure the drain tube with the drainage
system and clip on the rear of the
machine when finished.
Keep the door glass and gasket clean.
Drawer cleaning
Filter cleaning
Suggestions for moves or
prolonged disuse
The manufacturers warranty only
covers faults within the product of a
mechanical or electrical nature
Faults caused by handling,
installation or miss use are not
covered and may incur a charge for
any repair visit to resolve.
4. MAINTENANCE AND
CLEANING
To clean the washing machine exterior, use
a damp cloth, avoiding abrasives, alcohol
and/or solvents. To maintain a good wash
performance we recommend that the soap
drawer and pump filters are regularly
cleaned. A monthly service wash, using a
proprietary cleaner is also recommended.
We recommend you clean the drawer to
avoid accumulating detergent and
additive residue.
To do this, extract the drawer using slight
force, clean it with running water and
reinsert it in its housing.
Ensure the siphon cap is correctly
refitted.
The washing machine comes with a
special filter able to trap large residue,
such as buttons or coins, which could
clog the drain.
ONLY AVAILABLE ON CERTAIN MODELS:
pull out the corrugated hose, remove the
stopper and drain the water into a
container.
Ensure all the water has been emptied
from the drum.
Before unscrewing the filter, we
recommend you place an absorbent cloth
under it to keep the floor dry. A small
amount of water will come out of the filter
as you remove it - this is normal.
Turn the filter counter-clockwise to the
limit stop.
Remove and clean the filter; when
finished, replace it turning it clockwise.
The filter handle will be locked when it is
not possible to turn any further and the
handle is horizontal. Smearing a small
amount of liquid soap on the filter seal will
help refitting.
Repeat the previous steps in reverse
order to reassemble all parts.
Should the washing machine be stored in
an unheated room for a long period of
time, drain all water from tubes.
Unplug the washing machine.
Detach the tube from the drainage
system and clip on the rear of the
machine and lower it, fully draining water
into a bowl.
Secure the drain tube with the drainage
system and clip on the rear of the
machine when finished.
Keep the door glass and gasket clean.
Drawer cleaning
Filter cleaning
Suggestions for moves or
prolonged disuse
The manufacturers warranty only
covers faults within the product of a
mechanical or electrical nature
Faults caused by handling,
installation or miss use are not
covered and may incur a charge for
any repair visit to resolve.
A furniture plinth may be run
across the front of the dryer, but
its height will be dictated by the
front kickplate.
Plinth must have ventilation
slots (min. Side/diameter 127mm
hole) according to the dimensions
on fixing template.
If the plinth is not high enough
to accommodate the whole
hole, cut only part of it.
Place the template onto the
reverse of plinth. Mark the
screw hole positions, then drill
out these positions (figure 11).
Fix the plinth to the kickplate
using 6 screws provided. (J)
Note : it’s possible only some
types of kickplate (eg. wood or
plastic) . We suggest to check
with the kitcken supplier.
Fix the kickplate to the dryer.
In case of using full door, door
must have min. Ø127mm hole
across the slots of kickplate
(figure 12).
Figure 11:
Figure 12:
WITHOUT the airflow
ventilation
hole in the furniture
door/plinth we cannot guarantee
the correct functionality of
the appliance.
A furniture plinth may be run
across the front of the dryer, but
its height will be dictated by the
front kickplate.
Plinth must have ventilation
slots (min. Side/diameter 127mm
hole) according to the dimensions
on fixing template.
If the plinth is not high enough
to accommodate the whole
hole, cut only part of it.
Place the template onto the
reverse of plinth. Mark the
screw hole positions, then drill
out these positions (figure 11).
Fix the plinth to the kickplate
using 6 screws provided. (J)
Note : it’s possible only some
types of kickplate (eg. wood or
plastic) . We suggest to check
with the kitcken supplier.
Fix the kickplate to the dryer.
In case of using full door, door
must have min. Ø127mm hole
across the slots of kickplate
(figure 12).
Figure 11:
Figure 12:
WITHOUT the airflow
ventilation
hole in the furniture
door/plinth we cannot guarantee
the correct functionality of
the appliance.
11
EN
… 11 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hoover HTDBWH7A1TCE-80 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hoover HTDBWH7A1TCE-80 in the language / languages: English as an attachment in your email.

The manual is 14,28 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info