594726
6
Zoom out
Zoom in
Previous page
1/36
Next page
5.1 BEFORE USING THE OVEN FOR THE
FIRST TIME
PRELIMINARY CLEANING
Clean the oven before using for the first time:
•Wipe over external surface with a damp soft cloth.
•Wash all accessories and wipe inside the oven with a solution of hot
water and washing up liquid.
•Set the empty oven to the maximum temperature and leave on for
about 1 hour, this will remove any lingering smells of newness. Ensure
that the room is well ventilated while this is being done.
THINGS TO REMEMBER
Confirmation of operation on timer:
•Modification must be confirmed by pressing .
Stop the oven:
•This may be necessary if you have input an incorrect instruction. To
stop the oven, press the .
CLOCK SETTING
When the oven is connected to the electricity supply for the first time of
after a long power cut, the clock must be re-set.
To set the clock:
1.Press the for few seconds and find the by using ,
then press the ”. The digits on the central display will blink.
2.Set the clock by using then wait a few second or press the
again to apply your setting.
ADJUSTING THE DISPLAY CONTRAST
1. Press the for few seconds and find the ”by using ,
then press the ”. (The contrast of the display brightness is
included between “1” maximum and “5” minimum.)
2. Choose the contrast level by using then wait few seconds or
press the again to apply your setting.
NOTE: If you want to set the clock or to adjust the display contrast after
the first switching on of the oven, press the “ ” for switch on the
oven, and proceed how described in the points 1 and 2 of the specific
paragraphs.
MINUTE MIND
1.Press the for switch on the oven.
2.Press the for few seconds and find the ”by using the ,
then press the .
3.Set the required time by using the , then wait a few seconds or
press the “Temperature/Time SET again to apply your setting.
NOTE: This function allows oven to be used as an alarm clock
independently form the working oven.
CHILD LOCK
1. To set the child lock press for few seconds.
2.
To activate press “OK”
To activate press “NO”
NOTE: It is possible to activate child lock both when the oven in ON
and OFF
START
STOP
ON
OFF
ON
OFF
5.2 HOW TO USE OVEN
SINGLE MODE
To use the Single Mode, remove the seperator from the oven.
You can choose all the functions below with Single Mode.
The cooking methods suggested are set out in the table below. A
temperature is also suggested for each cooking method. This can be
modified within a pre-determined range.
06 GB
*Booster: rapid temperature raised
-
160
210
220
210
180
L2
210
240
40
60
NORMAL
Off
Bottom
Bottom+Fans
Bottom+Top
Bottom+Top+Fans
Circular Heating Element
+Fans
Grill
Grill+Fans
Grill+Turnspit+Fans
Defrost
Keep Warm
Pyro * **
-
50-240
50-240
50-280
50-240
50-240
L1-L3
180-230
180-240
No
No
ECO:425/65min
NORMAL:425/75min
SUP:425/1h30min
-
-
Booster
-
-
-
-
Booster
Booster
-
-
-
1.Press the to switch on the oven.
2.Press the ”. Choose function required to the cooking by using
.
3.The appropriate temperature or level cooking, according to the
cooking method selected is displayed. It can be modified within a pre-
determined range - see table above. To modify the temperature
setting, press the and choose the temperature by using .
Then press the again to confirm. The temperature display is
fixed but can be modified during the cooking cycle.
4.To start the cooking, press the . The oven will start
cooking and will start to heat up. The indicator light blinks until the
selection temperature has been reached. An audible sounds at the the
end of this operation and the indicator light becomes fixed.
5.To change the oven function, repeat the steps for 2 to 4.
6.To stop the cooking press the ”.
ON
OFF
START/STOP
START
STOP
DUAL MODE
To activate the Dual Mode, put the separator into the third position
shelf of the oven. You can choose the functions below with Dual Mode.
1- Press the switch on the oven.
2- Press the “ ” select which part of the oven cavity (UPPER or
LOWER) must be used; choose the function required to the cooking
by using the .
3- The appropriate temperature or level cooking, according to the
method selected is displayed.
It can be modified within a pre-determined range-see table below.
To modify the temperature setting, press the “ ” and choose the
temperature by using .
Then press the ”again to confirm. The temperature display is fixed
but can be modified during the cooking cycle.
4- To start the cooking, press the .
The oven will start cooking and will start to heat up. The indicator light
blinks until the selected temperature has been reached; an audible
sounds at the end of this operation and the indicator light becomes
fixed.
5- To stop the cooking, select the ”.
ON
OFF
START/STOP
Pre-set
temperature
°C
Function Mode according
to the oven model
Pre-determined
temperature °C
Function
Booster*
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hoover HOA 96 VX at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hoover HOA 96 VX in the language / languages: English, German, French, Polish, Spanish as an attachment in your email.

The manual is 1,27 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info