You are advised to also use this function for children's clothing and for delicate fabrics in general, or
when washing garments made of towelling, where the fibres tend to absorb a greater quantity of
detergent.
To ensure the best performance for your wash, this function is always activated on the Delicates and
Woollens programmes.
Delay Start
This option is available to delay the start of the wash cycle by up to 9 hours. The selection of the time is
completed by pressing the Delay Start button, the countdown display will indicate the time selected.
When the correct delay is selected press the Start Pause button to start the cycle.
Temperature
The Temperature button allows the reduction in the wash temperature in each programme. Each time
the button is pressed the temperature decreases until a minimum of 15°C (cold wash )
Note: The temperature must be adjusted before selecting Wash Time.
Fast Iron
This option is only available on the Synthetics, Acrylics, Woolmark and Silk programmes.
Spin Speed
The spin cycle is very important to remove as much water as possible from the laundry without damaging
the fabrics. You can adjust the spin speed of the machine to suit your needs. By pressing the Spin Speed
button, it is possible to reduce the maximum spin speed, and if you wish, the spin cycle can be cancelled.
To re-activate the spin cycle it is enough to press the button until the required spin speed is indicated.
It is not possible to select a spin speed higher than that suitable for the programme selected. This feature
is designed to avoid damaging the fabrics. It is possible to modify the spin speed at any time without
stopping or pausing the machine.
19
Programme
Synthetics
Acrylics
Woolmark
Silk
Fast Iron function
The programme is completed by a
short spin of very low speed.
The machine stops in the final rinse
stage and the option indicators blink.
The load is held in the water in the
drum, thus reducing creasing and
enabling easier ironing.
The machine stops in the final rinse
stage and the option indicators blink.
The load is held in the water in the
drum, thus reducing creasing and
enabling easier ironing.
The machine stops in the final rinse
stage and the option indicators blink.
The load is held in the water in the
drum, thus reducing creasing and
enabling easier ironing.
Action required to complete the cycle
To select a full spin cycle please turn the dial
to the required spin programme.
Press the Fast Iron button to continue with
the programme. The machine will then pump
out the water and the programme will
conclude with a short spin. Finally, the
programme carries out a brief tumbling
action to loosen the items in the load.
Press the Fast Iron button and the machine
will pump out the water and complete the
cycle with a short spin cycle.
Press the Fast Iron button and the machine
will pump out the water to complete the
cycle. The load will not be spun and will
therefore be very wet.
