Manual Hoover HBTDW H7A1TCE-80 (page 7 of 24) (English)

705508

Zoom out

Zoom in

1/24



Connect the water hose to the water

supply tap (fig. 3) only using the hose

supplied with the appliance (do not

reuse old hose-sets).



Some models may include one or more of

the following features:



HOT&COLD (fig. 4):

water mains connection settings with hot

and cold water for higher energy savings.

Connect the grey tube to the cold water

tap

and the red one to the hot water

tap. The machine can be connected to

the cold water tap only: in this case, some

programs may start a few minutes later.



AQUASTOP (fig. 5):

a device located on the supply tube that

stops water flow if the tube deteriorates;

in this case, a red mark will appear in the

window “A” and the tube must be

replaced. To unscrew the nut, press the

one-way lock device "B".



AQUAPROTECT – SUPPLY TUBE WITH

GUARD (fig. 6):

Should water leak from the primary

internal tube "A", the transparent

containment sheath "B" will contain water

to permit the washing cycle to complete.

At the end of the cycle, contact the

Customer Service Centre to replace the

supply tube.



The washing machine should be installed

in its final position such that the water fill

hose is not kinked or trapped. The

corrugated drain hose should be inserted

into suitable drain pipe of between 50 cm

and 85 cm height above the floor using

the curved drain hose support. If an under

sink connection is used the drain hose

must be routed above the sink overfill

opening to prevent back siphoning. Care

must be taken to avoid kinking or trapping

the drain hose (fig. 7).

min 50 cm

max 85 cm

+2,6 mt

max

max 100 cm

min 4 cm

Hydraulic connections

Setting



Regulate the height of the dryer

The 4 adjustable feet allow the

height of the dryer to be adjusted

from 827 mm to a maximum of

847 mm . To adjust the height, you

should rotate the adjustable feet,

ensuring that the machine is level

(figure 1).

Note : we suggest to Put the

dryer at the maximum height

possible in order to avoid tilting,

lefting at least 5mm from the

top of the furniture.



Before to fix the hinges it’s

necessary to determinate the

depth of the dryer from the front

part of the kitchen accordingly

with the dept of the kick plate

(check picture) and chose the

right installation option (figure 2).

Option 1

he position of the plinth of

the dryer is set back less than

54 mm from the front of the

furniture.

Position the template onto the

reverse of the furniture door. It is

possible to mount the hinges and

closure magnet on the right or

left-hand side depending on your

requirements. Mark the screw

hole positions, then drill out

these positions (figure 3).

Figure 1:

Figure 2:

Option 1:

Option 2:

Figure 3:

We suggest mounting the

furniture door so that it opens

towards the left, same direction

as the porthole door.

Instructions for mounting the

furniture door

consider the thickness of the

kickplate of the kitchen



Regulate the height of the dryer

The 4 adjustable feet allow the

height of the dryer to be adjusted

from 827 mm to a maximum of

847 mm . To adjust the height, you

should rotate the adjustable feet,

ensuring that the machine is level

(figure 1).

dryer at the maximum height

possible in order to avoid tilting,

leaving at least 5mm from the

top of the furniture.



Before fixing the hinges it’s

necessary to determine the

depth of the dryer from the front

part of the kitchen according

to the depth of the kick plate

(check picture) and chose the

right installation option (figure 2).

Option 1

The position of the plinth of

the dryer is set back less than

54 mm from the front of the

furniture.

Position the template onto the

reverse of the furniture door. It is

possible to mount the hinges and

closure magnet on the right or

left-hand side depending on your

requirements. Mark the screw

hole positions, then drill out

these positions (figure 3).

Figure 1:

Figure 2:

Option 1:

Option 2:

Figure 3:

Instructions for mounting the

furniture door

Note: That distance don’t

consider the thickness of the

kickplate of the kitchen.

'RQRWLQVWDOOWKHSURGXFWLQD

ORZ WHPSHUDWXUH URRP RU LQ D

URRPZKHUHWKHUHLVDULVNRIIURVW

RFFXUULQJ$WWHPSHUDWXUHDURXQG

IUHH]LQJ SRLQW WKH SURGXFW PD\

QRW EH DEOH WR RSHUDWH SURSHUO\

WKHUH LV D ULVN RI GDPDJH LI WKH

ZDWHULVDOORZHGWRIUHH]HLQ WKH

K\GUDXOLF FLUFXLW YDOYHV KRVHV

SXPSV )RU D EHWWHU SURGXFW

SHUIRUPDQFH WKH DPELHQW URRP

WHPSHUDWXUH PXVW EH EHWZHHQ  

& 3OHDVH QRWH WKDW

RSHUDWLQJ LQ FROG FRQGLWLRQ

EHWZHHQ  DQG & PLJKW

VLPSO\VRPHZDWHUFRQGHQVDWLRQ

DQGZDWHUGURSVRQIORRU





3UHYHQW LWHPV IURP IDOOLQJ RU

FROOHFWLQJ EHKLQG WKH GU\HU DV

WKHVHPD\REVWUXFWWKHDLULQOHW

DQG RXWOHW 1(9(5 LQVWDOO WKH

GU\HUXSDJDLQVWFXUWDLQV



$LU2XWOHWVLQWKH%DVH

:$51,1* 7KH DSSOLDQFH

PXVWQRWEHVXSSOLHGWKURXJK

VXFKDVDWLPHURUFRQQHFWHG

WR D FLUFXLW WKDW LV UHJXODU\

VZLWFKHGRQDQGRIIE\DXWLOLW\

,IWKHVXSSO\FRUGLVGDPDJHG

LW PXVW EH UHSODFHG E\ WKH

PDQXIDFWXUHULWVVHUYLFHDJHQWRU

VLPLODUO\ TXDOLILHG SHUVRQV LQ

RUGHUWRDYRLGDKD]DUG

7KHSOXJVKRXOGEHDFFHVVLEOHIRU

GLVFRQQHFWLRQ DIWHU WKH DSSOLDQFH

KDVEHHQLQVWDOOHG

Note : we suggest to put the

distance Note: That does not

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Hoover HBTDW H7A1TCE-80 in the language / languages: English as an attachment in your email.

The manual is 9,2 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Hoover HBTDW H7A1TCE-80 Manual

Product: