595272
4
Zoom out
Zoom in
Previous page
1/4
Next page
Z STUDIO > 04-2009 – Cod. 41031853
COUPLING OF THE PANELS OF THE BUILT-IN
COLUMN TO THE DOORS OF THE APPLIANCE
PRECAUTIONS FOR THE CORRECT
FUNCTIONING
Once the product has been built in, position the rear part of the column
in contact with the wall so as to prevent access to the compressor
compartment.
For the product to operate correctly it is essential to allow adequate air
circulation so as to cool down the condenser located in the rear part of
the appliance.
For this reason, the column must be equipped with a rear chimney, whose
upper opening must not be blocked and with a front slot which will be
covered with a ventilation grill.
The appliance is equipped with coupling devices for the appliance
doors with the panels of the column (drive sleds).
Open the doors of the built-in column and the fridge. Position the
built-in loader in the slide, then fi t it into the fridge door
Mark the fi xing points for the screws and drill with a bit of a diameter
of 2.5
Connect the appliance door to the cabinet panel using the sled slots
as references.
Dimensions of the column lock-pickings
Dimensions of the gap to be left between the column and the
ceiling
50mm
Fasten the sled in the inner part of the panel of the built-in column at the
desired height and at approx. 20 cm. From the outer wire of the door
20
540x50mm
540x50mm
380x37mm
380x50mm
575
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hoover HBCP 3050 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hoover HBCP 3050 in the language / languages: English as an attachment in your email.

The manual is 0,98 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info