0 EN6
Air Outlets in the Base
• Adequate ventilation must be provided in the room where the tumble
dryer is located to prevent gases from appliances burning other fuels,
including open fires, being drawn into the room during operation of the
tumble dryer.
• Installing the rear of the appliance close to a wall or vertical surface.
•There should be a gap of at least 12 mm between the machine and any
obstrubtions.The inlet and outlet should be kept clear of obstruction.To
ensure adequate ventilation the space between the bottom of the
machine and the floor must not be obstructed.
• Check regularly that the air flowing through the dryer is not restricted.
• Check frequently the fluff filter after use, and clean, if necessary.
•Prevent items from falling or collecting behind the dryer as these may
obstruct the air inlet and outlet
• NEVER install the dryer up against curtains.
• In cases where the dryer is installed on top of a washing machine, a
suitable stacking kit must be used according to the follow configuration.
-Stacking kit Mod 35100019: for minimum washing machine depth 49 cm
-Stacking kit Mod 35900120: for minimum washing machine depth 51 cm
The stacking kit shall be one of that above, obtainable from our spare
service.
The stacking kit shall be one of that above, obtainable from our spare
service.
The instructions for installation and any fixing attachments, are provided
with the staking kit.
Ventilation
0 EN6
Do not install the product in a low
temperature room or in a room where there is
a risk of frost occurring. At temperature
around freezing point the product may not be
able to operate properly: there is a risk of
damage if the water is allowed to freeze in
the hydraulic circuit (valves, hoses, pumps).
For a better product performance the
ambient room temperature must be between
+2°C and +35°C. Please note that operating
in cold condition (between +2 and +15°C)
might simply some water condensation and
water drops on floor.
