705518
17
Zoom out
Zoom in
Previous page
1/18
Next page
17
EN
9.
TROUBLESHOOTING
What Might be the Cause of...
Defects you can remedy yourself
Before calling service for technical advice please
run through the following checklist. A charge will
be made if the machine is found to be working or
has been installed incorrectly or used incorrectly.
If the problem persists after completing the
recommended checks, please call Service, they
may be able to assist you over the telephone.
Time display to end could change during
drying cycle. The time to end is continuously
checked during the drying cycle and the time
is adjusted to give the best estimation time.
The displayed time may increase or decrease
during the cycle and this is normal.
Drying time is too long/clothes are not dry
enough
Have you selected the correct drying
time/programme?
Were the clothes too wet? Were the clothes
thoroughly wrung or spindried?
Does the filter need cleaning?
Is the dryer overloaded?
The dryer does not operate
Is there a working electricity supply to the
dryer? Check using another appliance such as a
table lamp.
Is the plug properly connected to the mains
supply?
Is there a power failure?
Has the fuse blown?
Is the door fully closed?
Is the dryer switched on, both at the mains
supply and at the machine?
Has the drying time or the programme been
selected?
Has the machine been switched on again after
opening the door?
The dryer is noisy…
Switch off the dryer and contact GIAS
Service for advice.
The Indicator is on…
Does the filter need cleaning?
The Indicator is on…
Does the water container need
emptying?
CUSTOMER SERVICE
Should there still be a problem with your
dr y e r a f t er co m p l et i n g a l l t h e
recommended checks, please call
service for advice.
They may be able to assist you over the
telephone or arrange for a suitable
appointment for an engineer to call under
the terms of your guarantee. However, a
charge may be made if any of the
following applies to your machine:
Is found to be in working order.
Has not been installed in accordance
with the installation instructions.
Has been used incorrectly.
Spares
Service
Always use genuine spares, available
direct from service.
For service and repairs call your local
service engineer.
The manufacturer declines all
responsibility in the event of any
printing mistakes in this booklet. The
manufacturer also reserves the right
to make appropriate modifications to
its products without changing the
essential characteristics.
FOR ONE TOUCH MODELS
The Hoover Wizard app has a Clever Check-up function that allows you to confirm the
functionality and status of the product at any time. To use the Hoover Wizard app you will need an
Android smartphone with NFC technology.
More info can be found on the App.
If the display of the machine is showing an error (by a code or blinking LEDs), you should turn on
the App on your Android smartphone, with NFC on. selecting "Read the error" on the "Help on line"
menu place your smart phone against the One Touch logo on the control panel. You should now be
able to read the fault directory to solve the issue.
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hoover DX C10TG-80 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hoover DX C10TG-80 in the language / languages: English as an attachment in your email.

The manual is 20,94 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info