637663

Hoonved SP 5 Manual

14
Zoom out
Zoom in
Previous page
1/19
Next page
21
4. Press the button (1) to automatically begin filling the
washing tank. Light (4) will come on once the level has
been reached. The water inside the boiler (see light 6)
and the water in the washing tank will automatically
start heating.
5. Open the door and pour the quantity of detergent
indicated by the manufacturer directly into the tub. This
operation need not be carried out when the machine is
equipped with the optional dispenser.
6. After warning light (6) has gone out, wait about 20
minutes to allow the water in the washing tub to reach
the programmed operating temperature.
3.3.b Washing operation (Figs 9-10)
1. Load the dirty crockery into the basket according to the
configuration of the machine.
2. Open the door and fit the basket into the tub, then shut
the door again.
3. Press “START” button (3). Light (5) will come on to
indicate that the cycle has started.
4. Light (5) will go out to indicate that the cycle has
terminated. Now open the door and remove the basket.
5. Add a spoonful of detergent after every 5/6 washes.
This operation need not be carried out if the machine
is equipped with the optional dispenser.
The doses are indicative and not binding since they
vary according to the hardness of the water and utilized
type of detergent.
Cold rinse - Optional - (only for C 35 -SPB 35 Mod.)
The coolthe glasses, at the end of the cycle, press for a few
seconds the cold rinse button (7) Fig. 1/9.
IMPORTANT
The hot water supply (50°÷60°C) does not allow a manual
cold rinse to be obtained.
IMPORTANT
Keep the tub door closed between one cycle and the next
to prevent the water in the tub from cooling.
ATTENTION
Door opening during the cycle will block machine operation
in the same way as an EMERGENCY device.
To interrupt the cycle, open the tub door in the following
way:
• Slightly open the tub door. Wait a few seconds for the
water pressure in the rods to drop, then completely
open the door.
• This operation is very important since it prevents the
operator from being wetted or scalded as during the
rinsing phase, the water reaches a temperature of
90°C.
• Close the door and the cycle will continue from where
it was interrupted.
3.3.c Changing the water (Fig. 10)
This operation must be carried out after every 10 cycles or
so, depending on the amount of accumulated dirt.
1. Switch off the machine as indicated in paragraph 3.3.d,
then lift the overflow (21) and allow the tub to completely
drain.
2. Fit the overflow (21) back into its housing and repeat
the machine preparation operations as indicated in
paragraph 3.3.a.
3.3.d Daily regenerating operations (for mod. CD-
CRD-SPD-SPRD only)(Fig. 10)
The regenerating operations must be carried out once
work has terminated.
1. Remove the overflow (21) and reset the line button (1).
2. Keep button (2) depressed for a few seconds. Warning
light (5) will come on to indicate the beginning of the
regenerating cycle, which lasts about 20 minutes.
ATTENTION
Remember to keep the door closed during the
regenerating phase.
3.3.e Manual drain (Fig. 1)
(on machine with drain pump only)
To manually empty the water from the tub, switch off the
line button (1) Fig. 1 and push the START/DRAIN button
(3).
3.3.f Switch-off (Fig. 9)
At the end of the work day, set the line switch (1) to position
“0” OFF, disconnect the main switch installed prior to the
machine and turn off the water delivery cock.
ATTENTION
Disconnect the main circuit-breaker prior to the machine
and turn off the water delivery cocks if the dishwasher is
faulty or operates badly.
Only allow technicians from the manufacturer’s authorized
after-sales service center to make repairs.
4. CLEANING (Fig. 10)
4.1 General information
Strict compliance with the maintenance instructions in this
section will keep your machine in a good working condition
and will notably reduce the need for repairs.
ATTENTION
If any machine component becomes faulty, FIRST CHECK
that all the instructions given in the previous paragraphs
have been complied with during use.
Repairs must be carried out immediately, as soon as the
fault occurs. This will prevent the trouble from becoming
worse and damaging other parts.
ENGLISH
… 14 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hoonved SP 5 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hoonved SP 5 in the language / languages: English as an attachment in your email.

The manual is 0,26 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Hoonved SP 5

Hoonved SP 5 User Manual - German - 19 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info