689554
56
Zoom out
Zoom in
Previous page
1/62
Next page
54
Wireless connectivity Guide
Programmer or Timer
(ST9000RF)
To bind a Digital Room Thermostat (DTS92) to a Programmer
or Timer (ST9000RF) as a room temperature sensor...
On the Programmer or Timer
1
Move the setting slider to RUN
2
Press and hold , and (right hand
side) MODE together for 8 seconds – it
should briefly show “BIND MENU
3
Press until and SENSOR
are flashing on the display
4
Press and hold for 8 seconds to
clear any previous bind data – it should
show “RESET” for a few seconds
5
Press once
On the Digital Room Thermostat
6
Press and hold for 2 seconds
to put the unit into standby
7
Press and together for 3
seconds – it should display 'INst'
8
Press – it should display 'COnt'
9
Press three times – it should display 'CLr'
10
Press once to clear any previous binding data
11
Press – it should display 'COnt'
12
Press once to send the binding
signal to the Programmer or Timer
You should receive a COMPLETE message on
the Programmer or Timer and the LED on the
Digital Room Thermostat should stop blinking
and turn OFF. If not go back and re-bind.
Digital Room
Thermostat (DTS92)
56


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Honeywell Wi-Fi Evohome Controller ATC928G2000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Honeywell Wi-Fi Evohome Controller ATC928G2000 in the language / languages: English as an attachment in your email.

The manual is 4,1 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info