565055
15
Zoom out
Zoom in
Previous page
1/16
Next page
15
11. Help with problems
Error table
Problem/
Display
Cause Remedy
flashes Batteries flat Replace the batteries.
e1
sensor
Device defective Replace the device.
e2
valve
Motor can not be
moved.
Check the
installation.
The radiator
stays hot
The radiator valve
does not close
fully.
Check the
installation. If
appropriate, change
to full-stroke mode
(Parameter 8).
The room
does not heat
up during
optimization
Heating is not
switched on in
time
Ensure that the pre-
controller switches
on the heating.
Synchronize the on/
off times of boiler
control and radiator
controller.
Motor does not
move
Valve baseplate
not interlocked
Set the slider to the
position .
Emergency operation when batteries are flat
1. Unlock the radiator controller. To do so, push the slide
at the radiator controller towards .
2. Pull the radiator controller off the valve baseplate.
3. Operate the radiator valve by hand using the
adjustment dial on the valve baseplate.
+
Restoring the factory setting
1. Keep the PROG button pressed for approximately
10 seconds until Parameter 1 flashes (left-hand digit).
2. Use the adjustment dial to select Parameter 19 (left-
hand digit) and Setting 1 (right-hand digit).
3. Press the OK button to restore the factory setting.
12. Technical data
Type HR90
Protection class IP30
Supply voltage Battery type LR6, AA, AM3
Alkaline: 2 x 1.5 V
Lithium: 2 x 1.5 V
NiMH: 2 x 1.2 V
Power consumption Standby: typ. 165 mW
Control: typ. 240 mW
Control accuracy (CA) 0.5 °C
Connection to the radiator M30 x 1.5
Ambient temperature 0 ... 50 °C
Transport and storage
temperature
–20 °C ... 65 °C
Dimensions 96 x 54 x 60 mm
Weight 185 g (with batteries)
Ambient conditions For living area, business and
trade sections as well as
small businesses
Humidity 10 ... 90 % rel. humidity
Standards EN55014-1:2006 +A2:2011
EN55014-2:1997 +A2:2008
EN60730-1:2011
EN60730-2-9:2010
RoHS 2011/65/EC
CE
13. Disposal
The radiator controller has to be disposed of in
accordance with WEEE directive 2012/19/EC –
Waste Electrical and Electronic Equipment directive.
f At the end of the product life dispose
of the packaging and product in a
corresponding recycling centre.
f Do not dispose of the unit with the
usual domestic refuse.
f Do not burn the product.
f Remove the batteries.
f Dispose of the batteries according to
the local statutory requirements and
not with the used domestic refuse.
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Honeywell TheraPro HR90 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Honeywell TheraPro HR90 in the language / languages: English as an attachment in your email.

The manual is 5,31 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Honeywell TheraPro HR90

Honeywell TheraPro HR90 User Manual - German - 16 pages

Honeywell TheraPro HR90 User Manual - Dutch - 16 pages

Honeywell TheraPro HR90 Quick start guide - All languages - 4 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info