32703
26
Zoom out
Zoom in
Previous page
1/36
Next page
26
69-1119
Step 10. Check Thermostat Operation After Programming and Installing
Heating
Do not check heating system operation
by jumpering thermostat terminals,
such as the gas valve, zone valve, oil
burner control at the primary control.
This will damage the thermostat;
instead, jumper R and W wires at the
thermostat.
Move the System switch to Heat and
the fan switch to Auto.
Press TEMP key until the setting is
about 10°F (6°C) above room tem-
perature. Heating should start and the
fan should run after a short delay
(immediately if fan operation switch is
set in E position).
Press TEMP key until setting is about
10°F (6°C) below room temperature.
The heating equipment should shut off.
HeatCool Off
Auto On
TEMP
26


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Honeywell TD2200 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Honeywell TD2200 in the language / languages: English as an attachment in your email.

The manual is 0,28 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Honeywell TD2200

Honeywell TD2200 User Manual - French - 18 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info